Dyno Inc. B20 Turbo Integra Dyno Video

[HondaboyGsr]

is a built b20 turbo better than a build gsr turbo

[BriHatesU2]

lol @0:41 theres a nasty lil vacuum leak

[AlphaDemonWolf666]

How did you get that thing to hold so much power? Is it sleeved? B20/vtec?

[mistawhoady]

yall fuckin idiots your can push 26 lbs no problem

[Shazee083]

i dont get it how you get 23psi how you calculated that

[mikespec90]

Thats doesnt look like a leak on the manifold to me, id say thats blow by comming out of the vlave cover cuz it doesnt have a valve cover breather kit and may or may not have a block kit either. Watch any vids of hondas makin big number with breather boxes, at high boost and rpms they do blow a little smoke out of them, if you dont have one it will vent out the valve cover thats normal.

[chillincruisin]

wtf? how did it not blow? sleeved the shit out of it? and 4 doors make me sad :( i dont fit in them, im too tall.

[ImportsAreBetter]

@chillincruisin ok lets just end this myth now, ALL aluminum motors with aluminum blocks have iron sleeves, iron is A LOT stronger than aluminum, the sleeves wouldn't be in any danger of being destroyed unless its something crazy, not to mention, the energy from the combustion is directed mostly up and down, so the sleeves dont see much stress

[rs200000000000]

nice set up, did you have to resleeve the motor ?, also could i use a b20 bottom end on a b16 head ~? thanks

[ylism]

You have a bad leak on the intake. Made some nice numbers thou. yl

[xJayFitz]

@ylism I noticed that too, looked like a pretty nasty leak.

[justahatch]

good shit, to bad dyno inc. is gone like the wind.

[bhzrdrs4]

you are crazy

[Drewburney]

uh. leakin boost around the intake opening there bud. lol. might want to fix that. even tho this vid is reallt old.

[Sasukeuchihavsneji]

What's the setup

[BLACKURA87]

Thats sick,

[cocx88]

holy crap thats one nasty DA

[afghanr1dah]

db8* with jdm front ;]

[88specv]

@cocx88 tats not a DA..its DC