HydrogenTapCUBE(413)

[xaviorbat]

ok, I came in late by a referal from youtube...what is it for, is it the electrolyzing device?

[Eddlipton]

Hey John, nice work. I like your vids. You and Luc, "gotoluc" you two must have gone to the same school. He too does a great job with his instruction and display. Any chance of buying any of these Videos? i am limited to the internet access of dialup only and it takes almost an hr for 10 min of video to download,,if I don't lose connection, if I do I have to start all over again. NICE WORK!

[johnaarons]

Thanks for your interest

John AArons

[pphraznicholas]

God Bless You, my friend.

I've been watching your videos/postings for quite awhile and never tire of what you openly share with everyone.

You are a true pioneer in this area and I commend you for your tenacity and spirit of cooperation.

Best of luck, keep swinging for the fence and THANK YOU!

[johnaarons]

Thanks for your interest..

John AArons

[mcorrade]

oh my gawd. I had the same idead about a year ago. I had it configured the same way except I used SS rods (pull pins from angle brackets). I never got paste the final construction due to lack of tools (the right tools). I had try to job it out and the guy wanted way too much money. I think it's sound thinking!!!!!

[jesslessthemess]

nice craftsmanship. For drilling and spacing did you just double up your plexi sheets and drill through both?

[johnaarons]

I did that.. This cell is not my best work because I was rushed to complete it but good enough to be used in a demo. The only problem is that drilling should be done in a machine shop that is set up to do mult. holes. If you note there are some of the holes that are not used.. this is because they did not line up good enough..

John AArons

[cosmicmind1]

You are full of imagination and creativity, Thanks for sharing your ideas with all of us.

I think this one is great.

Have a good day Mr. Aarons.

[scarmenl]

That is way cool. Thank you for the idea. I can't begin to buy this type of thing due to still having fight the government for jailing me for a crime I did not commit and it leaves me with little in the way of funds.

[AlienNRG]

I also like the simplicity of this. Well done. And thanks for sharing.

[johnaarons]

It does work... I will try to get to it.. Lots of things going on here... in the energy dept.

John AArons

[llewgnal]

hello

[dsmtsi]

How would you ensure contact on each bolt head with the metal plate?

A better idea to ensure 100% contact with each bolt would be to add a nut on the same side as the bolt head to.

So you would have holes in the plate with the bolt going through and the nut on the other side of the bolt. You tighten the nut to ensure contact with the plate, then slide the bolts into the holes.

It would go bolt, metal plate, nut plastic.

I hope I explained it, it is hard without showing you a diagram.

[johnaarons]

What I showed you is just the idea... there are many types of bolts you can use and many types of plates also..

Thanks for your interest..

John AArons

[LarryMReed]

John I like this concept alot.

[johnaarons]

Thanks... the idea is to make it (K.I.S.S).. Don't count me out just yet..

John AArons