honda clone homemade exhaust

[Gokartcreator]

yha swabbster3

[Smallgasengine1]

does it make the engine quieter?

[swabbster3]

@Smallgasengine1 its about the same but it sound better in real life

[Gokartcreator]

your going to go pretty fast with it but if you had a tork convertor you would even go faster but the only down side of it is that there 200$.

[swabbster3]

@Gokartcreator ya but once you ship them there reilly expencive

[Gokartcreator]

Is that a four stroke

[swabbster3]

@Gokartcreator it is a 200cc 4 stroke engine

[ronaldhotboy]

Freakin awsome man. Cannt wait to see this baby run

[swabbster3]

@ronaldhotboy thanks im just waiting on my fuel pump and every thing else is ready and to go. how is ur boat going?

[ronaldhotboy]

@swabbster3 so far so good, just saving up to purchase the fiberglass and resin (arm and leg)

[shacodbe]

cool, i like the sound it makes. for the disc, u could probably buy one of those hubs u used for your wheels, like the 5 bolt drive plate or 4 bolt one that princessauto sells. they are pretty thick, and cheaper than a regular disk.

[swabbster3]

@shacodbe ya but there not tall enouph i was thinking at school take a piece of my 3/8 sheet metal and getting my shop teacher to put a hole in it then use the lathe to male it ballences and round

[picapop12345]

runz nice

[1972FordF150]

that thing is quiet! has that Honda clone been good?

[swabbster3]

@1972FordF150 it runs good but it is japenese shit very soft aluminum so bolts stip out easy my recoil blew up so i used a pry bar and ripped it off but if you take care of them they are sweet little engines

[outdoorsman310]

it looks good. you should put a stack on it! haha

[swabbster3]

@outdoorsman310 if i had a roll cadge i would but if it were to get rolled it would probley crack the head