Tesla Wireless Power Trasmitter

[DeadJack57]

Unless you are using a ground to conduct the power, it is just radio.

[RDarkhill]

How long until we can use this to power aircraft?

[g3jvl]

Hi You are seeing 30V peak to peak AC which is only (30/2)*0.707 rms = 10.6V so the lamp is lighting as it should. You need to see 42v p-p to get 14v rms.

[mimieowcat]

Very good work!

How`s about input/output power?

Do the input power increase when you put the second reciever? of load/unload it?

Thanks and take care!

[powermaks]

well, you can run that 14V light off of 2000 volts if you wanted to. if the wattage is the same. but some reason when you run a load at a higher voltage, it tries to "suck" power and burn itself up. i don't know why.

[PoirierMike]

Very good experiment.

[Iseekoutthetruth]

do you know anything about micro phonics capacitors?

[randomsrvapps]

Okay you are using induction you need to tune the coils to produce scalar waves and get the pitch right like what Prof. Dr.-Ing Konstantin Meyl demonstrated and you will find pancake coils will produce better results.

[advancedhydrogen]

your amps droped use a jule theif in the circuit and u will have more current

[HorizonDelta]

Good video ! More Tesla video: "Tesla cold electricity" by HorizonDelta

[Pujc]

If I understanding this right , there are two transmitter and in the midle the reciver tower right? And you have the bottom wire by the reciver conected to the earth? See if you have once time my vid, I have buildt such like you but just with one transmitter and reciver.

[MrCletushowell]

Plug in a dc iphone charger get 30 volts from

5 vdc from paralle the ground side to the ground wire 5 x 60 hz = 30 v ac free

19 volts maxes out free ac at 60 th hz

[MrCletushowell]

Ya the less power from receivers is due to us doing it wrong transmit the ground

Frequency pull the energy from earth

Im working on it think backwards everything

[MrCletushowell]

Short the wire between the light bulb

Its opposite of the regular grid drop the power on metter increase the flow some how it circles it back

[imatelly]

i dont know i was able during an experiment to harness the power from my fluorescent light using 2 cross like coils of wire,so maybe u could try more copper a secondary antena or something,i dont know u should look at the experament on my page,what i was doing had nothing to do with this though,cool vid

[slavric]

The osc. is showing 30Vpp, which divided in half is 15V or 10.6V of effective voltage. (1/sqr2) But the experiment is very exciting.

[99894159993]

Guy can any1 share their schematic ! i wanna c how it works !

[mikenz88]

The bulb is rated at 14VDC but you are looking at an AC peak-peak voltage so RMS will be close to 10V. The bulb and cable impedance at the frequency you are running will be higher than its dc resistance. The skin effect will also result in a higher AC resistance for your wires and coil and therefore reduced current and power

[ElectroJoltman]

The main reason I performed this experiment was to check what would happen when a second receiver was added to the system. The power consumption at the transmitter didn't change. but the second receiver did take some power from the 1st receiver, I observed the 1st receiver bulb get dimmer. so the total power transmitted is distributed by all the receivers. more receivers less power per receiver.

[PhuqueU]

what if you put 4 receiving coils around the transmitting coil?

[bigbadwolf3567]

not enough amps?

[cheaphardwarez]

This is power transmission by transverse electromagnetic waves.  This is not who tesla did it.

[paulreta]

The voltage induced in the coil is proportional to the number of windings. The reason the light doesnt lit much is because it isnt enough current induced. Thats why in other videos are using light bulb cases with just a single low consumption bright LED inside, just like intel does

[Pujc]

Wrey interesting , my wireless work really different .. are by your circuits , by the coils the ends coupled thogeder and in the ground? THX for your anfver ahead.!

[zezimashock]

can i have a schematic for that wave oscillator?

[DirteyApe]

can you feel anything if you stick your head in thier and would this be practicle honnestly for commercial use EG theise towers every couple miles around the countery to power eg teslar powerd cars wich exist

[xerochaos187]

u need a condencer for the sig recever and try to make an amp with its own recever .

[cabetecl]

Thanks.. I'm Still learning.

[crippled82]

30V ac = 21V rms

[crippled82]

If 30V is peak-peak, then rms is 10V