Hercus Compulathe threading with tool changer

[MrDondoerner]

Can you provide cost and timing to Waterloo,Ontario Canada?

Do you have a site for samples of parts that have been machined on your lathe including cycle times.dondoerner@sympatico.ca

[MrDondoerner]

Can you provide cost and timing to Waterloo,Ontario Canada?

Do you have a site for samples of parts that have been machined on your lathe including cycle times.

[capnjacksparrow1]

the tool changing is too slow when it rapids so far back, this must be the tc position i guess which is already set in the programme?

[togaida]

Hey after viewing the vid a second time...I can't see a problem at all, lol...the machine does what it has to with a passion, gets the job done and as it is said nowadays, "if it ain't broke, don't fix it" lol...keep up the good work.

[togaida]

Wow, beautiful machine...a little rough on the slides but the resuling work piece gives it a lot of credit, hope you'll share more project videos, nice very, very, nice.

[SupermaxCNC]

The slides are noisier than ball screws because they are a planetary screw design. More rigid than ball screws but a little noisy, especially now that these are 23 years old. I am looking at replacing them with ball screws but they have almost zero backlash so its hard to justify.