To use water as a fuel is bad. Our water is a precious resource and trying to make usable water from the ocean is expensive. The green movement would not allow de-salinazaion of sea water. There would be a fight from them.
@TheEvenOrder Do you know that about 70% of the earth's surface is covered in water?? Learn the electrolysis process.. and you will learn when you burn hydrogen you get water vapor back....
Very Nice. If you can afford to build with Stanless Steel. A poor mans unit is made with sch 80 Black Pipe. I made one over a year ago. One problem they will have is the Aluminum Oxide will sedal to the bottom and the hi heat 250 to 350 degrees F will bake it and it will harden. You need to set up a bottom drain so you can flush the unit while its running. first flush in 8 hours and then every 12 hours after the first flush some times sooner depending on the size of the run.
I think the method they were using for the hydrogen production is not electrolysis. I think they were dissolving aluminium in a sodium hydoxide solution.
But you're right; they probably are putting more energy into it then they're getting out.
yes, it would have to be a chemical production of hydrogen just so it can have a pure Hydrogen output for the PEM cell. as you know brown gas doesn't work in Pems.. you must have hydrogen on one side and oxygen on the other. i wonder are they using SODA CAN's as a Aluminim source?
the even order- you are a retard.
dmgcat 1 year ago
To use water as a fuel is bad. Our water is a precious resource and trying to make usable water from the ocean is expensive. The green movement would not allow de-salinazaion of sea water. There would be a fight from them.
TheEvenOrder 2 years ago
@TheEvenOrder Do you know that about 70% of the earth's surface is covered in water?? Learn the electrolysis process.. and you will learn when you burn hydrogen you get water vapor back....
taztaz79 3 months ago
Very Nice. If you can afford to build with Stanless Steel. A poor mans unit is made with sch 80 Black Pipe. I made one over a year ago. One problem they will have is the Aluminum Oxide will sedal to the bottom and the hi heat 250 to 350 degrees F will bake it and it will harden. You need to set up a bottom drain so you can flush the unit while its running. first flush in 8 hours and then every 12 hours after the first flush some times sooner depending on the size of the run.
teh770 3 years ago
hydrogen generator for fuel cell or enginees
it is good job
tony8668 3 years ago
hydrogen generator for fuel cell or enginees
tony8668 3 years ago
humm. 12+ volts for the hho production, to run a 1.5v Hydrogen cell?
ahahaha.
danratsnapnames 3 years ago
I think the method they were using for the hydrogen production is not electrolysis. I think they were dissolving aluminium in a sodium hydoxide solution.
But you're right; they probably are putting more energy into it then they're getting out.
RupertsCrystals 2 years ago
yes, it would have to be a chemical production of hydrogen just so it can have a pure Hydrogen output for the PEM cell. as you know brown gas doesn't work in Pems.. you must have hydrogen on one side and oxygen on the other. i wonder are they using SODA CAN's as a Aluminim source?
danratsnapnames 2 years ago
Nice set up. Can you give us some information on it?
gagekko 4 years ago