When uniting a two-piece mold, I heard that one must create "channels" to allow excess casting material to escape, thus creating a better casting. It doesn't appear that you do this--any thoughts?
I got a problem, if i sculpted my sculpture, i vaseline it , and then i go over with ultracall ( i sculp with oil based chavant sulfer free clay) the ultracall always wants to run to 1 point and it's hard to cover it fully than
I love working with silicone and I found your technic both entertaining and informative. I'vve been making prosthetics for 23 years and still find myself challanged with every project. Got to love it. Good job.
@GThe0dd0ne0ut If you are very careful removing them. I find it is cheaper just to recast them. This appliance only cost about .75 cents.
brickintheyard 11 months ago
When uniting a two-piece mold, I heard that one must create "channels" to allow excess casting material to escape, thus creating a better casting. It doesn't appear that you do this--any thoughts?
creepsomber 1 year ago
@creepsomber I did create an overflow area but in this case it was very crude. This is a very simple mold for small appliances.
brickintheyard 1 year ago
I'm so sorry if you get this comment several times--it doesn't appear to be working!
Great videos! I've spent hours watching them and picked up several hints. What ratio do you use of water to Murphy's?
PS--any videos around of making acrylic nails? I can't get mine clear
megandmax 1 year ago
Comments are approved 1st to reduce spam. Murphy's 1 part - water 3-5 parts.
brickintheyard 1 year ago
@brickintheyard Thanks so much!
Sorry if I spammed you!
megandmax 1 year ago
@brickintheyard Thanks so much!
Sorry if I spammed you!
megandmax 1 year ago
@brickintheyard Thanks so much!
Sorry if I spammed you!
megandmax 1 year ago
@brickintheyard Thanks so much!
Sorry if I spammed you!
megandmax 1 year ago
lol, "backside mould"
random99skills 2 years ago
Thanks! Cheers!
brickintheyard 2 years ago
from a list of your products, what would you say is a good material for spider man webs
IRellevant 2 years ago
Any urethane rubber would be good I suppose.
brickintheyard 2 years ago
I got a problem, if i sculpted my sculpture, i vaseline it , and then i go over with ultracall ( i sculp with oil based chavant sulfer free clay) the ultracall always wants to run to 1 point and it's hard to cover it fully than
metalgrunger06 3 years ago
You may need to mix your Ultracal thicker or build a clay dam around the positive.
brickintheyard 3 years ago
I love working with silicone and I found your technic both entertaining and informative. I'vve been making prosthetics for 23 years and still find myself challanged with every project. Got to love it. Good job.
Batmanfw 3 years ago
Need to get a new application video. The old one featured mt ex-wife.
brickintheyard 3 years ago
What? i don't get what's so good about it!
trainerfabri 3 years ago
Is there a way to learn/do this for full face prosthetics and foam? Thanks!
baileym4 3 years ago
You are awesome. That's all there is to it.
creepsomber 3 years ago