Sort by time | Sort by thread (beta)
- Your queue is empty. Add videos to your queue using this button:
or sign in to load a different list.
Loading...Saving...
Loading...Saving...
Nicely done... Thanks for the vid!
HammerspurRI 4 days ago
No oil seal on the new bolt?Does it leak?
MrHopgoblin 3 months ago
@MrHopgoblin Maybe there's very, very small leak, I did not notice anything, I think you can use a little teflon tape if some leakage was observed
But now I recently replaced it with a new OEM
ameenalbriki 3 months ago
Very nice, clean, good job. i just did almost the same to my 08 ktm exc 450, it killed two stock cct's and one DT cct. maybe i'll make a video, as i've yet to see my application addressed. 10mm bolt x 1.00 pitch, 90mm's long. head machined down and the bolt ran from the inside out (threw the stock 21mm cct capturing nut) with jam nut on the outside. grooved the end of the exposed part of the bolt for screw driver head. works awesome, don't over tighten!
teamvisser 4 months ago
@teamvisser Thanks and good luck for you
ameenalbriki 4 months ago
what song is this?
MartyJr10 6 months ago