Priming and tipped primers on a Lee Load Master press

[DarwinTe]

Opps. Link on the left, not the right.

[DarwinTe]

Thanks, MascotAL. We've been discussing these new primer assemblies in my forums. No one had made a connection with bad results and a die in station 2 yet. I relayed your comment there.

loadmastervideos . com and click on the link at the right for the forums.

[MascotAL]

Great video thanks. One thing I would like to add. You can not use a second sizing die for priming if you are using the new replacement system from lee. I installed the new prime system on my press and started crunching primers. I found that if I removed my second sizing die the primers started to feed normally.

[tahadda64]

you and shadow heave the best videos,, very informative,, i have a question, how do you know which slider to use with which primer,, my press was given to me with no directions and i cant find which one to use

[TFMTraining]

Interesting theory. It does make sense. I can see my bench top move when I pull the ram up. However, I think I'll reinforce the table top before I dig a hole in the floor (like your next video) :-) Thanks for sharing.

[scarletlacemusic]

Nicely done video.

[manintoynenam]

you will need a primer pocket cleaner

[spitgalore]

Very informative, thanks.

[shadowdog500]

I love the side view shot without the priming system installed. It took me a while to figure out what I was looking at, but it is a great angle.