PICAXE 08M R/C Switch

[SwagSociety01]

can you give me the programme code you used plz?

[Mapendekete]

@SwagSociety01 Hi there. This is several years old and I am afraid I no longer have the program I wrote for this. However, I seem to remember it was a simple process if you look up the pulsin command to read the input from one of the Rx channels and then conditionally perform whatever function you want depending on the signal state.

i.e in the above example, if the pulsin value was higher than a certain value (e.g the mid-point of the PWM) it would pass the signal from the Rx direct to the servo