Thread Cutting on Lathe 1K62 with homemade single point threat cutter

[UPlai]

How did you adjust the automatic feed for the thread? there is no 1.5 on the drum...

[FactoryDragon87]

@UPlai Well, I just switch the thread cutting regime on my lathe feed gearbox, then I use the clutch for turn the spindle forward and back. If You carefully look on the drum form 1:24 to 1:27 then You see the M24x1,5 ... sorry for my camera bad viev quality.

[UPlai]

@FactoryDragon87 Thx. camera is great! can you show howto switch the gearboxes for cutting a thread on the 1K62? would be interesting...

[atofinkelstein]

FactoryDragon87: It was interesting.

P.S. are you latvian ?

[FactoryDragon87]

@atofinkelstein Yes, I am the Latvian. P.S. What here is so interesting?:-)

[atofinkelstein]

@FactoryDragon87 : I am latvian too. I just see rise of interest in mechanics and metalworking/CNC/3DP in Latvia.

[FactoryDragon87]

@atofinkelstein Or in one of Riga's Institute?