This has been flagged as spam show
VHola una consulta como puedo hacer un extrude pero con 30° de inclinación. Por ejemplo : primas inclinado de base cuadrada o pirámide inclinada.
6Rinnegan 4 months ago
i have 2011, I enable HUD but what means compatability mode.???
PanPrezesxD 1 year ago
This is only in Inventor 2011, which version do you have?
If you have 2011. Go to the Application Options on the Sketch Tab enable the Heads Up Display (HUD). Also make sure you are not running in compatability mode.
imaginittech 1 year ago
where i can find this dynamic input in inventor????
This has been flagged as spam show
VHola una consulta como puedo hacer un extrude pero con 30° de inclinación. Por ejemplo : primas inclinado de base cuadrada o pirámide inclinada.
6Rinnegan 4 months ago
i have 2011, I enable HUD but what means compatability mode.???
PanPrezesxD 1 year ago
This is only in Inventor 2011, which version do you have?
If you have 2011. Go to the Application Options on the Sketch Tab enable the Heads Up Display (HUD). Also make sure you are not running in compatability mode.
imaginittech 1 year ago
where i can find this dynamic input in inventor????
PanPrezesxD 1 year ago