How To Properly Drill Into Metal

[Wolfenion]

How do you know your hole is at 90 degrees with a hand held drill??

[gnosismonk]

Calipers are not for marking out how stupid....

[SirBlackAcid]

@gnosismonk Apparently his are.

[Swamplord1000]

that's one fancy centre punch

[Thasleem1971]

thank you very much, very helpfull, very easy to understand though if you can also post thye names of the drill bits, since i am a asian cannot understand much of your english accent qwhen you speak, drill bit i can understand, spot drill i understood, there are two other drill bits you mentioned could not catch up

[FulhamFCCottager]

Very helpful information for drilling into my classic car. Thanks!!!

[william4art]

OH geez!!! shouldve figued Id see someone using a measuring instrument for scribing lines. How about a heigth gauge? or in this case...... an adjustable square.. wow! so many videos on here showing people how to hack!!

[boostercorp]

if you're drilling into aluminium you can just remove the burs with a sharp knife

no expensive tools needed ;)

and the spot drill is also not necessary just use a normal centerpunch and hit it with the hammer 2 - 3 times

an normal centerpunch cost less and won't break ;)

and if the tip is dull you can just resharpen it

hes hopeing you will buy those tools in a shop that is sponsoring him ;)

[tindlebears]

can this method be applied to stainless steel?

[rho070]

If you don't have a countersink bit, you can minimise most Alu burs by using a wood block underneath.

[5horsepower]

thats a nice centre punch

[thickblkpa]

nice...just need the tools now.