Level the vice so it is 0° to the x axis then take of the vice, clamp a piece of coldrolled steel or something precise directyl onto the table with some sort of fixturing.
Then turn the vice over and tighten it to the piece of bolted down Steel, then remeasure of you still got the angle in it and then just facemill of the bottom of the Vice.
Done.
But first I would check the millingtable, wouldn't be the first time the table was tilted.
Level the vice so it is 0° to the x axis then take of the vice, clamp a piece of coldrolled steel or something precise directyl onto the table with some sort of fixturing.
Then turn the vice over and tighten it to the piece of bolted down Steel, then remeasure of you still got the angle in it and then just facemill of the bottom of the Vice.
Done.
But first I would check the millingtable, wouldn't be the first time the table was tilted.
erklaerbaer01 1 year ago
@erklaerbaer01 Thanks, I'll check that out tomorrow.
TheWreckingYard 1 year ago