Looks like perhaps the rails were spliced a bit too high in the turn right before the loop (You can see the track dip a little bit through this part). That's the reason it goes a bit slow through the twist. Otherwise, it looks great!
Hey. I have a Pheonix too but mine stopped working about 3 days ago and when it comes to the twist it either stalls on the turn into the station or goes down the dip to the station and the silver thing sticking out at the begining of the station stop it and push it backwards. Can you please respond because I worked 6 hours straight and I don't want it to have been a waste.
Be sure you followed the directions correctly. Are the rails cut at the right point? Also be sure all of the rails are pushed into the 'cross ties'. This is a common mistake. If all else fails, wipe the track with silicon spray (this is detailed in the hints and tips section)
is it hard to build?
aimaddict419 1 year ago
@aimaddict419
Not really, it just takes patience. But the instructions are pretty straight forward, and I recommend buying it.
rollerghost615 1 year ago
It neally didn't clear the zero G roll at the end. Did you find this easy to build?
coastermadab 2 years ago
Yes, it goes slowish through the corkscrew, but it has never stalled, and it works perfectly fine. :)
And it was very easy to build, it just takes a bit of patience, it is much easier than the Scorpion and Dragon kits thats for sure! :)
rollerghost615 2 years ago
Looks like perhaps the rails were spliced a bit too high in the turn right before the loop (You can see the track dip a little bit through this part). That's the reason it goes a bit slow through the twist. Otherwise, it looks great!
coasterdynamix 2 years ago
@coasterdynamix
Thanks
rollerghost615 2 years ago
Hey. I have a Pheonix too but mine stopped working about 3 days ago and when it comes to the twist it either stalls on the turn into the station or goes down the dip to the station and the silver thing sticking out at the begining of the station stop it and push it backwards. Can you please respond because I worked 6 hours straight and I don't want it to have been a waste.
kaboda317 2 years ago
Be sure you followed the directions correctly. Are the rails cut at the right point? Also be sure all of the rails are pushed into the 'cross ties'. This is a common mistake. If all else fails, wipe the track with silicon spray (this is detailed in the hints and tips section)
DLDude 2 years ago
HAHAHAHAHA "OH GOD THAT WAS NASTY!!!!!" he just dissapeared!!!
kaboda317 2 years ago
@kaboda317
lol
rollerghost615 2 years ago
NICE (call me back now if you can)
kaboda317 2 years ago
@kaboda317
I will!
rollerghost615 2 years ago