Is it possible to use 390 coromillmill with long edge for ramping? What's the max angle? I'm talking about the 32mm dia, 3 cutting edges R390-032C6-45M.
Catalogue states only ramping angles for regular 390 end mills.
PabloXC 6 months ago
Amazing
mitchell169191 10 months ago
'
cutting alumiuium block is easily than harden steel block
bestamerica 11 months ago
@bestamerica
it is steel
LegoBastler 9 months ago
ı say: very good ı love hard machines. ı am a turkish
bravo sandvik
suvari23 2 years ago
yuh lan beygirmişiniz harbiden de
Sorry I can not translate this to english?
coromantchicago 2 years ago
This comment has received too many negative votes show
why dont you move the table against the blades?
f14phoenix 3 years ago
This has been flagged as spam show
"why dont you move the table against the blades?"
Why don't you shut up?
No seriously, the table IS moving against the cutter. That's why the cutter is stationary in the video.
JTMarlin8 2 years ago
@f14phoenix
That would be conventional milling. If hes on a CNC, you don't need to conventional mill. No backlash.
HertzCOD4 1 year ago
Is it possible to use 390 coromillmill with long edge for ramping? What's the max angle? I'm talking about the 32mm dia, 3 cutting edges R390-032C6-45M.
Catalogue states only ramping angles for regular 390 end mills.
PabloXC 6 months ago
Amazing
mitchell169191 10 months ago
'
cutting alumiuium block is easily than harden steel block
bestamerica 11 months ago
@bestamerica
it is steel
LegoBastler 9 months ago
ı say: very good ı love hard machines. ı am a turkish
bravo sandvik
suvari23 2 years ago
yuh lan beygirmişiniz harbiden de
suvari23 2 years ago
Sorry I can not translate this to english?
coromantchicago 2 years ago
This comment has received too many negative votes show
why dont you move the table against the blades?
f14phoenix 3 years ago
This has been flagged as spam show
"why dont you move the table against the blades?"
Why don't you shut up?
No seriously, the table IS moving against the cutter. That's why the cutter is stationary in the video.
JTMarlin8 2 years ago
@f14phoenix
That would be conventional milling. If hes on a CNC, you don't need to conventional mill. No backlash.
HertzCOD4 1 year ago