Fisher Paykel Dishwasher Servicing Fisher Paykel Dish Drawer Repair

[sirpinketalfonzo]

thank you very much sir! ive now used both of your repairs! :D

[ute445]

thank you for the help

[jezjonson]

I have the exact same dishwasher and mine will not empty. The red fault light is not on and I have no error messages. What do I do here? Is the drain tube blocked perhaps?

[tomcliffordwaldron]

my top drawer stops gets stuck mid cycle. when i open the drawer the water only feels luke warm so i am thinking it is the heater element and the drawer is not moving onto the next part of the cycle as the temperature sensor is not sensing that the water has reached a high enough temperature. can anyone confirm this. would anyone recomend me filling the drawer in diagnostic mode turning on the element and then using the temperature check to see if it heats up?

[TheGoldenhare]

A big thank you all the way from Scotland! Just managed to remove drawers myself to remove machine! I was trying to do this for hours before I watched your video. Thanks again, Corrina

[parisheavymetal]

Thanks for the video guys. I had the F1 problem and by following these instructions i managed to fix it.

[qingqing13]

I cannot start dishwasher...followed all directions shown here. No water in pan. The gasket has a bit of 'chewing'. I push start and get a few little notes...deh dehdeh deh...no better description: no action. The panel works.No 'F' symbol...just the little song when I press start. We have very hard water that we soften but the inners of d.washer dulled...I run a cleaner through every couple mos.

[owen2005]

I have removed the top drawer and rechecked the top drawer action and find that it is struggling to drop at the front and looked like it was getting a little stuck. I loosened the foam around it but Would I be better to put a bit of oil on the contact between the moving parts that go down.

Thanks for your help, you saved me a lot on money here

Owen

[ApplianceAdvice]

@owen2005 Right on friend:) Glad we were able to assist you.  Thanks for taking the time to drop us a thank you note:)

[owen2005]

Thanks, I eventually got rid of the F1 error by taking out the electrical board and hairdrying the whole bottom and board.

That fixed now the problem is that my top drawer is leaking when it is on. I have looked at the inlet and outlets but nothing there and changed the rotary thing in the centre (can't think of name) but I suspect the top lid isn't coming down correctly on the drawer but have I a way of checking that? Could there be leaking from the underside?

Thanks for reply

Owen

[owen2005]

I have an F1 error code and I have dried out the pans, the F1 code comes on and a noise like trying to empty the Drawer. I have done the diagnostic check but there is no movement on the rotor or the lid. I have checked impeller and although 1 is worn the other is fine, the The F1 error comes back on again and I have to turn off again.

Is there something else that I can try?

Owen

[ApplianceAdvice]

@owen2005 Hi, if the F1 error keeps coming back there is water in the base or the filter board down there could be giving a false signal that its shorted..

[MrLooster]

Thank you so much!!!! I was pulling my hair out with three children and husband at work. Had it sorted in 2 mins after watching your video. You are a saint!!!!

[ApplianceAdvice]

@MrLooster Your very welcome friend!! Glad your back up and running. Thanks for taking the time to leave a comment.

[inzertive]

Hi,

Do you know how to drain a Fisher and Paykel Dish Drawer thru the control pannel?

[fisherPayorKill]

HERE IS MY REPAIR, VISIT "FISHER PAYKEL BEST USE" ON YOU TUBE

COME ON, $1500 and 12 month warranty. Here you can see the Flood Pan, but believe me, water flows right over that and keeps on going if your not home. Plus, see the plastic box in the left rear of flood pan, that is the main electrical input to computer board, yes, lets run the electrical input in the flood pan, you start to see the bright design and why you better be home for an F1.

[voodoochef100]

@fisherPayorKill .......your repair is wiser than having some homeowner who is not familar with electrical appliances, hoping to fix it themselves. If experienced techs can not repair them, chances are you're not going to be able either. Plus you're putting yourself and family members at risk of bodily harm.