HHO Test on Cell with Manafold 3 LPM 7 Plates !

[legogunguy001]

The pump reduces an effect that occurs in the cell called polarization which is the build-up of bubbles on the plates. The pump blasts the bubbles off the plates therefore introducing more water to the plates. Also the pump helps lower the temperature of the cell because of the water circulating through it.

[Me102288]

ok so as far as I understand it, your acomplishing the same thing as just uping the voltage to the cell and letting the extra hho you get cause more pressure to lift the cup faster. I Think some of these guys are getting same thing I am, your wasting power in a pump instead of putting more power into the cell?

[oddssodds]

How many watts does you pump pull?

[llewgnal]

Nice production, so with pump are you makeing more gas? Check out my Maxflow 3 screen cell or "plates",aprox 1 ltr/3 min right now considering leaks, have to grt it contained...?

[ssfuturescott]

yes it is making more gas the amps go so the gas gose up see the side link.

[HHORevolution]

What do you use for gasket material between your plates? Thanks!

[lakeratlarry2]

looks good is that running like 6.31 mmw

[H2O2FromH20]

I calculate the MMW at 6.2, what was your cell before the manifold modification?

[ssfuturescott]

No the pump is not on the amp side of power draw. the pump is on 110 ac .5 amps

[Gforce1956]

Sorry my mind got ahead of my typing. Very awesome results. I meant to ask if the pump current was included in the amp reading. I get just under 6MMW without temp compensation. Good to see honest results.

[Gforce1956]

Any idea what pump is pushing in terms of flow?

Is the flow included in amps? I notice drop in gas flow with 1.4GPM pump on EBN cell. Not sure if it is leakage going up or I am pumping to hard.

[H2O2FromH20]

Restrict your flow after the pump and see if it helps.