@NeXxUnO you have to use the washers that came with the package, so you can adjust the stem height....... about the length, im not sure if its the same question i answered, but horizontally, the length is just fine. you just have to make some adjustments on the cut in because the faceplate has longer fader holes
Hello you happen to have had problems with the length of the fader?
In another numark mixer because I had trouble closing the case did not fit the fadercap.
NeXxUnO 2 months ago
@NeXxUnO you have to use the washers that came with the package, so you can adjust the stem height....... about the length, im not sure if its the same question i answered, but horizontally, the length is just fine. you just have to make some adjustments on the cut in because the faceplate has longer fader holes
digitaldrag2 2 months ago
@digitaldrag2 I installed a innofader a numark pro sm and I had problems even with the height of the washers.
At the end of the fader cap could not be put in and I had to paste.
I will try to disconnect it from the mixer and install it on x5.
Thanks for the reply.
Greetings from Italy.
NeXxUnO 2 months ago
AND WATS YOUR OPINION? I HAVE THE NUMARK NS7, HAVE THE SAME FADER AS THE X5, TELL ME ITS MUCH BETTER WITH INNOFADER? THANKS ;)
arturommk 3 months ago
@arturommk I felt the cp-pro got too short cut in..... innofader felt 3x smoother and i had the cut in adjusted according to my style
over all... definitely better than cp pro
digitaldrag2 3 months ago