Autodesk Inventor Fundamentals - Basics of Part Modeling Chapter 6

[MercedesBenzS600LAMG]

Thanks ROB

I like your commenting, as for me a beginner, you did really gave a lot of information :)

Thanks again !

[CariagaXIII]

this tutorial is hot lol

[Kid2Lt]

OK. I finally finished... Thanks. I got it done. It looks exactlly as you have. thanks again... It could have been much easyer. Just take it step by step, no comentary. Like someone that has never touched it. But I thank you anyway. I got throught it. Still wana smack you,..

[xNfs4masterSx]

@Kid2Lt hush ur mouth. Im sure hes commentary helps alot of people, especially when u dont know what he did then u can revert back and listen. I know it helped me significantly and hes tutorials are what is driving me towards the engineering category in my life. Good Job Rob, this program was confusing after using blender, but you sure made it simple. :-)

[PocketDrummer]

I wish you covered the tutorials for part 1 and 2. I'm using Inventor 2012 (student) and the tutorials just link to the Autodesk site. They assume the reader knows more than they should know and now I'm stuck at "Create a Revolved Feature" because their tutorials suck. I got to the Project Geometry part, and I don't know what they want me to do exactly. Also, the green dot doesn't even appear when I try to use the line.

I guess I'll just have to skip it and move to the next video tutorial.

[MySniperfi]

@PocketDrummer i have the same problem i was fine up till here though someone plz help!!!!!

[MySniperfi]

@MySniperfi ok pocket drummer i figured it out when you click the tutorial link and it takes yo to the website click the little plus button next to the tutorials tab then click the little plus button next to the inventor tutorials tab after that click the little plus button next to the projects tab then you will see a tab that says "about this tutorial" click on that, it will then take you to a diffrent page. in the first paragraph there will be a link click on that and download and follow the

[MySniperfi]

@MySniperfi inscturcions for the installationa and then go back to robs tutorials and it should worl from there plz tell me if this helped

[zacaalex1966]

Rob, Excellent tutorials. You are great teacher. I made this part no in fifteen minutes, but two hours. This is my first one!

Muchas gracias senor, es usted un perron para trabajar con Inventor. Felicidades!

[dan110024]

I want to have all of your knowledge in my head, now. :)

[seriousninja]

Thanks great tutorial!!!

[caslok]

thx rob ur the rockstar of inventor

[Dic3r4ever]

well done!

[cullio00]

10 of 10 for all tutorials!!!