Makita polisher shines for M & M

[sweetlikeADAM]

Would never trust this guy to use a power tool on my car. He lets it set in one spot, sever times, for way too long AND he put the polisher on the ground. Plus, he filmed this with a calculator... -_-

[ultimatecarvaleting]

@sweetlikeADAM

And who tell you I can trust you?

With out to know anything you comment your rubbish here.

The buffer for your information is up side down the pad never touch the floor and I don't use a calculator ether I use my phone.

Also customer it was happy with the results, and don't just comment on people's channels, get out from you tube!!!!!!!!!!

[ultimatecarvaleting]

@Leimlek Thanks dude !!!

[Benny77771]

Im new to Makita. Where did you get the pad (what is it) and at what speed are you polishing at?

[ultimatecarvaleting]

@Benny77771 Pads is 3M look for 3M stores, or visit my website and search on my links!

If you start with cutting pads always start slow at number two-three speed on the makita, with soft pads you can speed up to 4-5 speed, always check the panels if is not too hot and if the polish brake/dry clean your pads with special brush, don't wet the pads, and start over again an till you are happy with your results!!!

I hope I help with that.

Kind Regards

Matheos

M & M Detail

[ANDROSTENEDIOL]

You love it :-))

Nice job-what are you using as a wax ???

[ultimatecarvaleting]

@ANDROSTENEDIOL Hello there I use Paul Dalton's Crystal Rock wax!!!

Kind Regards

Matheos

M & M Detail