Keep up the good work. I saw one diagram in which another capacitor was used to capture whatever back EMF may occur in his circuit thus increasing the efficiency of the circuit.
I'm not sure if your circuit needs that or not. But his spark was actually more powerful after doing that.
i think your Idea of using the high voltage spark plug wire as a trigger is good. I had the same Idea, it's more simple than trying to use a pickup coil. Where is your ignition coil in this circuit? Or are you just using a capacitor?
since it tried a little bit maybe you are on the right track .maybe it just needs bigger jets now ,I heard you have to use bigger jets for more water than it needed for running on gasoline.
If I build one for my scooter (kymco 125cc), is it ok for daily use? I'm not an expert electrician, please advise (adiibn@yahoo.com), thank you.
Adiasmara100 6 months ago
i have a question... where can i find the value of those capacitor? i can't find one the voltage rating up to 630V only.....
tazein022 1 year ago
you will have to back the timing of the motor to tdc(top dead center)gas burns at 10,000 fps hho burns at 40,000 fps( feet per second)
and you will need 2x the water as gas to run
use a garden mister hooked up to a garden hose
and spray it in the carb.
holywdtughguy 3 years ago
Hmm... sounds like you have been playing with these all ready!:)
Did it worked for you?
tiltfulll 3 years ago
Keep up the good work. I saw one diagram in which another capacitor was used to capture whatever back EMF may occur in his circuit thus increasing the efficiency of the circuit.
I'm not sure if your circuit needs that or not. But his spark was actually more powerful after doing that.
swollwerth 3 years ago
Can you tell me where can I find that circuit?
Thanks!
tiltfulll 3 years ago
i think your Idea of using the high voltage spark plug wire as a trigger is good. I had the same Idea, it's more simple than trying to use a pickup coil. Where is your ignition coil in this circuit? Or are you just using a capacitor?
swollwerth 3 years ago
Yes this circuit just use a capacitor+the hv from the bbq igniter(in my trial setup) or from the ignition coil.
tiltfulll 3 years ago
cool
johncarl43447 3 years ago
Yeah but it was just gas
the mover has some issues that i going to fix,
than try again!
First it should run on gas!
tiltfulll 3 years ago
since it tried a little bit maybe you are on the right track .maybe it just needs bigger jets now ,I heard you have to use bigger jets for more water than it needed for running on gasoline.
johncarl43447 3 years ago