PIC Stepper Motor Controller

[mszazlina]

plssss teach me how to do thiss

[cidylong]

Hi, Sagutric

I am looking for a stepper controller, your one is quite match with my requirement.

1. The kit comes with two switch support. When I keep pressing button one, it spins left, when I keep pressing button two, it spins right, when I stop pressing, it don't move.

2. I hope its spin speed can be set up by jumpers or switch, my expectation is about 15 degree per second, I don't want it spin too quick.

If you get my information, please reply me at cidy.long@gmail.com

[SuperReiah]

hi, can you share me the hardware circuit and programming for this project? i badly need it. tnx.

[SuperReiah]

hi! what pic nicrocontroller did you used in this project? tnx.

[divdgr8]

i had that done recently in my embedded class wid my PIC18F4620

[marcelitavideos]

Please, can you share the hardware circuit and programming for this controller? :)

[joedanial]

quite a facinating vid..im a novoice in diy cnc router and is currently building one...can u share the circuit schematics for the stepper motor...thankz

[skuer85]

hi this looks very fascinating..can you share the hardware circuit and programming for this controller?

[SAGUTRIC]

Hi there. Thanks for your interest. I am in the process of compiling this project. Will let you have the detail once it's done. Stay tune. Thanks.

[SAGUTRIC]

Hi there. Let me have your e-mail address so that i can send you the schematic diagram and source code. Thanks.

[SuperReiah]

@skuer85

hello, did you get the hardware circuit and programming for the stepper motor? can you lend me a copy? I badly need it please.

[SAGUTRIC]

Hi. For the microcontroller part, i am using PIC16F84A. Where as the driver side, i am using ULN2803. Thanks.