Real Reset Samsung CLP 310/315/ прошивка Samsung CLP 310/315 part 1

[autocarventuri]

my friend....do you have the metod via serial number?

[acer6530]

what about samsung clp-320

[bozkurt25100]

Rock müziği çok seviyorum. Bunu söyleyen kim.

[johnvpr]

anyone tested this tecnique on clx-3175?

[erwinvb09]

I started with the first set of toners (without the chip) "Yellow 63%, Magenta 63%, Cyan 63%, Black 11%". I know the black is very well below 30% but I decided to try it anyway.

I turned on the printer, report gives 463 pages printed, I print some pages and print another report, 465 pages. I turn off the printer and turn it back on: report says 463 (mono) pages printed.

My guess is that any job that would require more than 11% black can not be printed anymore in one session without reboot.

[tryplex92]

is working tnx for tutorial

[tryplex92]

when i finish this thing how must be the toner level and the page counter from the test sheet? sorry for my bad english

[metonol]

@tryplex92

hang the counter on the data that were

[tryplex92]

@metonol

today i printing some pages and the toner level is going down my os version 1.29.11.08

[boxers1998]

thank you

[zurgafur]

Who sings the last song????

[falcon9i]

Redalert2 Music ! :D

[Herakleian42]

I did what you suggested, but after the toner level went below 30% for two colors. As you have said the counters didn't go to nill. Do you think they will reset when I buy and install two original toners? Your second video including programmer is not for me. Now I'm a bit worried about whether the printer will recognize the new toners.

[metonol]

@Herakleian42

printer recognize the new toner!

chip seal on a new cartridge

[tiwarygaya]

@metonol my CLP 310 Yellow toner is empty . how i can refill ? whether after refilling , my printer will work properly ?

[hassantu87]

does this work with clp-315?? thanks

[Ruffitsme]

Я делал так же. Действительно работает. До сих пор (больше года, наверное уже...).

[99spinz]

ok, 2. is solved. My black cartridge has a chip. Problem?

[99spinz]

1. What happens if you do this with less than 30% Toner?

2. How do I print this test sheet??

[metonol]

@99spinz

the answer to your question

in lesson № 2

[erwinvb09]

@99spinz

1. As far as I can tell this hack disables writing to the chip but the chip will still be able to count. This means that if you have 1% left in the toner which is enough for let's say 30 pages the printer will stop working after printing 30 pages because it thinks it's out of toner. You can turn powercycle the printer and it will think again you will have 1% toner left and your facing the same issue after 30 pages. 30% is a safety limit because most print jobs can be done within 30%

[erwinvb09]

@99spinz

2. If you press the "orange triangle in a circle" button the green led will blink, keep it pressed and it will start to blink faster. Now release the button and voila; a Configuration Report. (if you don't press it long enough (the green led is still blinking slow) you'll get a regular demo page for this printer)

[simnovv]

sucks i kill my printer because this chip is soo smal

[jawadamin3]

after i did this,my paper keeps on jamming, n den after i open/close door, it brings paper up a bit den jam again, den i have to open the top cover n pull out the paper..:$ same thing keeps on hapening again n again, please haelp =(

[hb9tlk]

Works like a charm. Everytime i switch the printer off, the page count goes back to 6 pages. THANK YOU !

[vukotici32]

Yellow Status Ready Remain Toner (64%) Magenta Status Ready Remain Toner (76%) Cyan Status Ready Remain Toner (76%) Black Status Ready Remain Toner (43%)

what would happen if i do this with my current Supplies Status

[metonol]

@vukotici32

all is well! having such a status of toner you can do firmware

[vayoran]

does this works with cpl 350n?

[metonol]

This discharge is suitable for Samsung 310,315, SAMSUNG CLX-3170/3175

all the luck =)

[vukotici32]

can i demage the printer with this metod ????

[vukotici32]

work this metod for the model CLP-310N manufactured february 2010 with firmware:v4.01.06 (clp 310) 01-23-2009

[redcode5]

thank you

it works like a charm

respect

[vukotici32]

@redcode5 what is the exact model, and firmware by you printer

[1234drive]

It works amazing

the simplest and the cheapest solution .

[acer6530]

good video....

but i have 1 quetion...why must be up to 30% on toner?

[50n1x]

@acer6530 cause this firmware most probably freezes that number and it would be non-sense to save it at a number where you are allways warned etc. So just make the printer think, it's full instead of almost empty.

[homonymsarehere]

does this method work on the newer CLP-325 printer from samsung?

[50n1x]

@homonymsarehere I don't think so, those printers will have a newer firmware with some different features.