@mrasiansensation two things you have your throttle control on the remote is maybe going all or nothing end everytime you touch the switch it revs out or you may have a bad servo that runs the linkage to the carb
@FeTTsackism Well obviously, if you dont flip it back upright and throttle up, going straight from 3D and upside down to normal mode will just result in no power and your heli falling on its head..
@alishanmao i have a question about my nitro rc buggy. when i drive it, it revs on its own. whats making it do that and how can i fix it? it would mean a lot.
for a heli to do this, it needs symetrical rotors and not flat bottom. Just like an rc plane that can do basic stunts. It too needs symetrical wings and not a flat bottom wing. That way the rotor can produce lift on either side of the wing. Along with symetrical rotors the heli needs to be able to cycle the pitch up or down. Thats basically how its done, but someone can probably explain it better than I.
The blades are what is called 'full collective pitch' which allows the angle of the blades to change. This allows the air to be pushed either way through through the rotors without reversing the direction of the rotation.
the blades are shaped like this \ to make it go upsidedown.. if its a good helicopter it could swith on its own and it would change to this position / if you look at a chopper you will see that they are turned a lil bit.. do it the other way the air will go the other way if that made sese haha
well said or when doing this grass cutting, just from no where you see it getting crash and plunging into ground. then engine not shutting and seeing heli going like fish out of water LOLROFL
I work for a company and to get our job done we have to walk on lawns. One out of every 1000 people complains about walking on the lawn. I ask them how the flip do you cut it without walking on it? And I always want to point out to them this is the only way they can cut their grass without walking on it!
I tried to trim my grapevine with my Honey Bee King vII, It toasted my wooden bnlades, cracked one of the blade grips & snapped on of the landing skids (The skid was already bent upward... too far from its previous crash).
You mean how much we charge to cut your grass with TREX600 Nitro or how much is this heli? well this Heli can cost up to 1500 to 2000 USD depending upon your setup :D
im not so good with one of my nitro cars? was out earlier today. and cliped a curb and it must of knocked out the transmitter fuse located in the car bed. so my expensive £800 pro 180cc 40engine went 130mph into a car wheel. im gutted hahahahaha was funny though. i had to run after it before it shot off on the rampage again. fail safes are useless :P
no its cool. im actually good now. really good in fact. i just been on a nitro heli course. a guy has trained me from my local model shop. it was kinda like geting driving lessons. but yeah? he says im just as good as he is now and he is pro.
Be careful mate. Cuz when crash in during this stunt, you don't know where the main rotor blades will go, and they don't just go parallel to ground at same height, they change directions and shoot, stones or stuff at you :D
wtf the stupid ad came up as soon as you got to the grass
raptor50trex 1 month ago
(
awesome)
andreynegrulya 1 month ago
hey you are expert to control that mine was lozer
johnmanolo05 2 months ago
the future of gardening....
XLR8OR100 2 months ago
lol no more lawn mower eh
sharky0578 4 months ago
you have nerves of steel to put them blades that close to the ground :O
ShaunBrownTV 4 months ago
@mrasiansensation two things you have your throttle control on the remote is maybe going all or nothing end everytime you touch the switch it revs out or you may have a bad servo that runs the linkage to the carb
bigbryjack75 5 months ago
grass is fking long! easy
GoffalignT 6 months ago
Perfect lawn mower for people who fly rc helicopters
XLosSantosX 7 months ago
nice
Mr4RC4king 8 months ago
@jordanhuusy and what makes you think only tony has the skills to do that? I can do much more than he does. before advertising here, think twice.
alishanmao 8 months ago
Can it be used to SHAVE BUSH??????
globalmilind 9 months ago 12
@globalmilind yes for sure
alishanmao 8 months ago 2
Not that impressed, my flymo also collects the grass, LOL!! Very good flying....
MrPants1970 10 months ago
ha ha ha !!!!!!!!!!! this is cool
hero8808 1 year ago
will it help me if im skilled in flying miniature pulse jets?
TheShadowfexx 1 year ago
Chuck Norris cuts his grass like this but with a full sized helicopter
jamesmcip 1 year ago 34
This is the answer behind crop circles.
lexmark136 1 year ago
please answer: when you are upside down, can you switch from 3d to normal mode? or will you crash?
FeTTsackism 1 year ago
@FeTTsackism Well obviously, if you dont flip it back upright and throttle up, going straight from 3D and upside down to normal mode will just result in no power and your heli falling on its head..
no1doesitlikeme 1 year ago
nice driveing
2strokebeast 1 year ago
ugh my heart lol
MsCountryboy11 1 year ago
Easy!
speedy02 1 year ago
chuck norris simply glances at his lawn and the blades of grass kneel to him.
xxwesdogxx 1 year ago 26
@xxwesdogxx ahahahhaahah facepalm hilarious
mike85sx 8 months ago
im not using my lawn mower anymore
L3gItSniPZ 1 year ago
mom: go cut the yard!!!
you: i dont want to!!
mom: NOW
heli rwewwwwwwwww!!!!
mom: Y R U PLAY WITH THE HELICOPTER!!!!
you: its the new hip way to cut the grass! duhhh!
mom: oh
dodgebot10 1 year ago
another ROFLCOPTER!
technogadget13 1 year ago
Did "shan mao" mean in chinese is 山猫?
NikkoBellic100 1 year ago
@NikkoBellic100 I have to research on this one
alishanmao 1 year ago
@alishanmao i have a question about my nitro rc buggy. when i drive it, it revs on its own. whats making it do that and how can i fix it? it would mean a lot.
MrAsainsensation 9 months ago
you can cut my grass any day ;)
DaCrab69 1 year ago 8
@DaCrab69 I just bought myself a TREX600 Nitro pro and I will sure come and cut your grass :D just send me visa and ticket.
alishanmao 1 year ago 9
thats nice boy, now lawnmower finaly i came to use
leviterande 1 year ago
What The! I was Watching this and A Scotts Lawn Add Poped up! xD
RobertSmithLOL 1 year ago
@RobertSmithLOL haha
nealshireman 1 year ago
Now THAT'S a fun way to cut your grass.
shashoni109 1 year ago
that is awsome
sunfiremyfriend 2 years ago
i love how fast these things shoot off once you drop the throttle
BadIdeas101 2 years ago
Actually they change the angle of the blades and that makes alot more lift. Also if they change it enough they can fly upside down and cut grass.
frosty9595 2 years ago
@frosty9595
i guess i should have said drop the collective lever then lol
BadIdeas101 2 years ago
cool
hioffroader 2 years ago
lol
Klubas666 2 years ago
how can the helicopter fly upsidedown?
can anyone explain?
Grasmanek94 2 years ago
for a heli to do this, it needs symetrical rotors and not flat bottom. Just like an rc plane that can do basic stunts. It too needs symetrical wings and not a flat bottom wing. That way the rotor can produce lift on either side of the wing. Along with symetrical rotors the heli needs to be able to cycle the pitch up or down. Thats basically how its done, but someone can probably explain it better than I.
jeepman65 2 years ago
well maybe some pics of the rotorz? hehe as i like heli's etc but i only have a RC car as i think i fuck up a heli/plane..
last time i modded my RC electric plane it blow up in the air cuz was too high voltage ! XD
Grasmanek94 2 years ago
its a collective pitch helicopter
CrazySnake99 2 years ago
The blades are what is called 'full collective pitch' which allows the angle of the blades to change. This allows the air to be pushed either way through through the rotors without reversing the direction of the rotation.
uncleshibba 2 years ago
inverted pitch angle..
tegots 2 years ago
the blades are shaped like this \ to make it go upsidedown.. if its a good helicopter it could swith on its own and it would change to this position / if you look at a chopper you will see that they are turned a lil bit.. do it the other way the air will go the other way if that made sese haha
drumfreak14 2 years ago
we all it a 3d helicopter , it has gyros and it knows whe he is turned so you control has he is normal , high and expensive technology.
jorgecosta95 2 years ago
well um lol ye many things are expensive.. just go to the shop and buy a police RC plane for $ 30 000 xD
Grasmanek94 2 years ago
if u give the money i dont have any problem xD
jorgecosta95 2 years ago
I'm sure Bill Gates can give me just 0,00001% of his money xD
Grasmanek94 2 years ago
good luck
jorgecosta95 2 years ago
is is just 40.000 dol :/
jorgecosta95 2 years ago
if he gave me 0,000001%(calculated ;p) of all his money i would have exactly enough for the plane xD
Grasmanek94 2 years ago
gosh dont they smoke :)
jthornley12 2 years ago
grass..........!
dragunovliebbherr35 2 years ago
the worst part for a nitro helicopter owner would be to watch it come crashing down from the sky,,, OUCH!
imy2k07 2 years ago 2
well said or when doing this grass cutting, just from no where you see it getting crash and plunging into ground. then engine not shutting and seeing heli going like fish out of water LOLROFL
alishanmao 2 years ago 3
theres a video of a german (i think) dude having that problem, rather painful but hilarious :)
Virtical 2 years ago
nice t-rex :)
vacaarecoada 3 years ago
i used to go cut grass with a cox .049 on a stick XD
AllAroundBang 3 years ago
I work for a company and to get our job done we have to walk on lawns. One out of every 1000 people complains about walking on the lawn. I ask them how the flip do you cut it without walking on it? And I always want to point out to them this is the only way they can cut their grass without walking on it!
Delticola 3 years ago
Yup but this is one hell of an expensive lawnmower and needs skills too :D
alishanmao 3 years ago
Thanks mate. Frankly, I am not the Heli pilot. that heli belongs to my friend (My bro) and he is a great Heli pilot :)
alishanmao 3 years ago
I tried to trim my grapevine with my Honey Bee King vII, It toasted my wooden bnlades, cracked one of the blade grips & snapped on of the landing skids (The skid was already bent upward... too far from its previous crash).
NZ
-King Of The Skies-
Av8r2991 3 years ago
LOL. use a bigger nitro heli and add some sharper blades LOL.
alishanmao 3 years ago
how much is this?
J4AProductions 3 years ago
You mean how much we charge to cut your grass with TREX600 Nitro or how much is this heli? well this Heli can cost up to 1500 to 2000 USD depending upon your setup :D
alishanmao 3 years ago
wow thats so expensive lmfao i rather get a plane or a used car for that much!
J4AProductions 3 years ago
yeah that would probably worth buying :D
alishanmao 3 years ago
there are cheaper beginner helis
the blade mcx a tiny co axial ready to fly for $130 with 2.4G controller its a great deal. it weighs 1oz!
i got my eye on the heli-max novus Cp also pretty cheep full 6ch 3d
BuffaloWarrior7 2 years ago
y should try with human hairs :P
aisqutis 3 years ago
We did thought of this but did not find any volunteers :) if you like, We are ready to give you a perfect haircut free. :)
alishanmao 3 years ago
Yup, but this lawnmower is so expensive and delicate plus requires so many skills.
alishanmao 3 years ago
yes. i will be posting lots of vids very soon. just need time to do it all.
EvilResistance 3 years ago
ok good news! just checked over my model. he is a ok :) but......need a new fly wheel and car body base hahaha
EvilResistance 3 years ago
Make one that is like Ironman's suit :D
alishanmao 3 years ago
im not so good with one of my nitro cars? was out earlier today. and cliped a curb and it must of knocked out the transmitter fuse located in the car bed. so my expensive £800 pro 180cc 40engine went 130mph into a car wheel. im gutted hahahahaha was funny though. i had to run after it before it shot off on the rampage again. fail safes are useless :P
EvilResistance 3 years ago
did you get it on video? you will lots of hits due to this video :D
alishanmao 3 years ago
no its cool. im actually good now. really good in fact. i just been on a nitro heli course. a guy has trained me from my local model shop. it was kinda like geting driving lessons. but yeah? he says im just as good as he is now and he is pro.
EvilResistance 3 years ago
Thats nice. i hope I had a heli trainer. How long did it take for you to be at this level?
alishanmao 3 years ago
i did this the other day...and out of luck i got it stable lol then almost crashed. i have a trex 600
EvilResistance 3 years ago
Be careful mate. Cuz when crash in during this stunt, you don't know where the main rotor blades will go, and they don't just go parallel to ground at same height, they change directions and shoot, stones or stuff at you :D
alishanmao 3 years ago