Added: 5 months ago
From: TheBossManhunt
Views: 1,694
Sort by time | Sort by thread (beta)

Link to this comment:

Share to:

All Comments (19)

Sign In or Sign Up now to post a comment!
  • alright dude just thought i would let u know that the peice of plastic in the uv light holding the bulb in place should be removed it could over heat and melt. good filter though i have the cf 500 and love it !!

  • Comment removed

  • Purigen is an excellent synthetic product, provided it's not saturated (with inorganics). Unlike carbon however, it can be recharged (bleach)! The Eheim media (round) is called "Substrat Pro" and has amazing surface area -- In fact, more area than the ceramic rings, but they are great too. Both are very effective.

    Bio-balls are good for nitrogenous bacteria as well, but detritus can get trapped over time -- Rinsing Bio-Balls in tank water (during maintenance) is highly recommended.

  • I think the Eheim media from the video is a prefilter for your polyfoam media. I would place it at the bottom, then the foam, next the c-nodes for bio packed full and finally the chemical media of your choice. Think you would prolong the life of the foam and get better filtration. Just a suggestion but nice job. That is pretty good water flow.

  • Quick reply. With adequate water changes many have gotten away from the use of carbon, With your tank being heavily planted I wondered what your nitrates generally ran and what was the trigger point for water changes. Keep the videos coming. I am purchasing that canister as it seemed to have more than enough room to add mech and biological filtration.

  • @TheWalk23 I never tested my water for nitrates because I'm sure the plants and bacteria in the substrate and canister took care of that for me. I do water changes on that tank once a month now because the small fish have such little impact on the waste levels. The plants do seem to like the fresh water too, they pearl every time after a water change. Yes that filter does have such open space for loads of filtration media.

  • Good video. I have been researching this canister filter and think I will buy. I have a 75 gal with two HOB of which I will replace one. Like the spray bar. Wondered why you went with bio balls in a canister, they are more effective in a wet dry application, instead of more ceramics. How long would you expect between the need to change out filter pads, and why are you using carbon ?

  • @TheWalk23 I was using bioballs because i wanted to try them out, I found out later that they aren't very effective in a canister. I was just using carbon to see how much cleaner my water would get and also to remove the smell from the water I only keep it in for a week or so because it removes the good stuff also. I would say changing the pad would depends on how much bio load your tank has. I change or clear my pads and stuff about every 3 months.

  • good video. i subbed. check mine out and please sub back

  • @bm20197 thank you, I subbed to you also.

  • Cool video,man...

  • I hooked it up last night it was brand new. I have TONS of pressure. I am not using the spray bar. It just returns form the elbow down into the tank..

  • @Mrwirez oh ok if you just set it up then it should push the remaining bubbles out pretty soon. I don't remember but i think my filter did the same thing for a short period of time. how big is your tank? Just make sure it's below the tank and you will be good to good...goodnight sir its bed time for me.

  • @TheBossManhunt My intake is on the bottom. I am using it for two large water turtles. Thanks for replying. You have a nice setup. I will turn the pump off and try to purge the water out. Then I'm heading to the pet store for more ceramic and media. Your video was a big help.. Thank You

    I will wait for a couple weeks for the filter to get dirty before adding new media..

  • @Mrwirez how long have you had the filter? I believe it could be because there isn't enough water pressure pushing down on it in the tank since it's half full for turtles. Also it the filter below the tank?

  • @TheBossManhunt I have the same pump. It's been running for 24 hours and still has air in the system. HOW did you get ALL the AIR OUT? I have small bubbles and you can hear some air in the pump... Not much though.

    P.S. I see you added a lot more ceramic and bio-balls. Where did you get all the extra filter media? Thanks

  • @Mrwirez make sure its sealed tight and all the baskets are down in there good. use Vaseline or petroleum jelly to lube the o-ring that will ensure its flexible never dry out. where is your intake located? I usally start my filter with water in it.

  • @Mrwirez Oh and I just went to the pet store to get them or you can look online. amazon have them pretty cheap.

Loading...
Alert icon
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more