Feed these machines for years, never seen one run that slow.
kgdies 5 months ago
@kgdies
Young lad on press normal is about 1200iph
Have set as slow as 300iph to train new operators or heavy foil emboss coverages
937die 5 months ago
@937die
My box plant has a Windmill, 29" Miehle, 2 Brauss 30x44 a 30 x 42 Unicutter auto platten.
Did a lot of presentation folders over the years for the printers, my guess the left hand feed is because the printer registered to the off lay.
My remark was just a teasing :)
speed that bad boy up, hoss....good vid.
lanetxgp1 2 years ago
100shows
Registration was critical. Higher guides can be a problem if sheet curls.Trimming to change side guide is not 100%.
937die 3 years ago
I know a left hand feed is difficult all you have to do is trim the page and reset the lock-up holes....and try using high guides .
100shows 3 years ago
Loading...Saving...
Loading...Saving...
Feed these machines for years, never seen one run that slow.
kgdies 5 months ago
@kgdies
Young lad on press normal is about 1200iph
Have set as slow as 300iph to train new operators or heavy foil emboss coverages
937die 5 months ago
@937die
My box plant has a Windmill, 29" Miehle, 2 Brauss 30x44 a 30 x 42 Unicutter auto platten.
Did a lot of presentation folders over the years for the printers, my guess the left hand feed is because the printer registered to the off lay.
My remark was just a teasing :)
kgdies 5 months ago
speed that bad boy up, hoss....good vid.
lanetxgp1 2 years ago
100shows
Registration was critical. Higher guides can be a problem if sheet curls.Trimming to change side guide is not 100%.
937die 3 years ago
I know a left hand feed is difficult all you have to do is trim the page and reset the lock-up holes....and try using high guides .
100shows 3 years ago