Sort by time | Sort by thread (beta)

Link to this comment:

Share to:
see all

All Comments (13)

Sign In or Sign Up now to post a comment!
  • Una grandissima stronzata!!

  • you cant do "in face flying 3d effects" without making focus on them!

  • Animation is in error,Shows no real push over, Blades have no "Coning" and cyclic input,after a tail strike the yaw rate is higher during break up phase of accicent. See Franks safty course its better.

  • So that's why my tail rotor was missing!! All this time I thought it was sky thieves!!

  • This fails to show the cause of the negative low G pushover, what would happen in reality is the cyclic is pulled back then pushed forward aggressively causing the above effect

  • Comment removed

  • I noticed your rotor disk does not tilt at all during the low-G entry, but the fuselage tucks nose low. The real hazard is the rolling that comes with the low-G, caused by the tail rotor thrust above the vertical center of gravity, which cannot be corrected with the cyclic at low-G.

  • @rotorznwingz so what u say is dont roll otherwyse u might wil die

  • @7249xxl Avoiding the low "G" condition is paramount, followed by no abrupt control movements. However, if a roll is encountered, do not apply opposite cyclic to stop the roll until the rotor is reloaded. Gentle aft cyclic is ok to reload the rotor. The is is based on RHC's guidance on the subject, since there is no flight testing regimen for low "G" conditions; avoidance is key by limiting abrupt control movements (particularly foreward), intentional low "G" entries and severe turbulence.

  • I'd hate to be in that Robbie.

  • this video look oddly familiar... i wonder where you got it lol rob ryder will smack you lol wish i had some 3d glasses, looks like it would be sweet

  • !! wow ... nice !

  • nice training video

Loading...
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more