Serials for THIS product? Ha, good fucking luck. I grabbed the trial version. Tip, don't try to freeze the trial version's time, or erase all the Reg Key entries, or anything like that. It doesn't work, you'd be better off buying the software if you want to get serious with it.
It would make sense that you hook them up like normal motors, but with different inputs. Like motor 1 -> input 1, motor 2 -> input 2.
I'm still not sure if I completely understand your question, like I said I haven't used EasyC in forever, and I've basically replaced all my knowledge with LabView.
My guess is that you would have to hook it up so that when the insructions get to motor 1, it also forwards them on to motor 2 as well. I'm not entirely sure if it's even possible though, I haven't used EasyC since I made this video, and I never really got into the intricities of it.
Nice, I'm taking robotics right now still loking for Serials around.
Achokiador 2 years ago
Serials for THIS product? Ha, good fucking luck. I grabbed the trial version. Tip, don't try to freeze the trial version's time, or erase all the Reg Key entries, or anything like that. It doesn't work, you'd be better off buying the software if you want to get serious with it.
rfryworld 2 years ago
that was made clear in the manual, i see robots with like 6 motors, 1 for each input on the controller, any idea on doing that?
thebegul 2 years ago
It would make sense that you hook them up like normal motors, but with different inputs. Like motor 1 -> input 1, motor 2 -> input 2.
I'm still not sure if I completely understand your question, like I said I haven't used EasyC in forever, and I've basically replaced all my knowledge with LabView.
rfryworld 2 years ago
how do i use easy c to program multiple motors (more than the 2 controlled by the joysticks) to be controlled from the remote control?
thebegul 2 years ago
My guess is that you would have to hook it up so that when the insructions get to motor 1, it also forwards them on to motor 2 as well. I'm not entirely sure if it's even possible though, I haven't used EasyC since I made this video, and I never really got into the intricities of it.
rfryworld 2 years ago