Arnie? Am I the only 1 having an issue with my G540? If the LED works the probe signal doesnt, if I flip the wires the probing process works but the LED doesnt. I am running a 48vdc ps to the G540. Should I have an additional resistor in place?
@CncObsession Could be 2 things. Easiest is reversing the sensing for probing in the Mach3 setup. I think that will solve it. The other, (less likely to be the problem) is to reverse the polarity of the LED. The Gecko is setup for a normally closed sensing circuits. But changing the the sensing polarity doesn't actually swap the polarity of the connections. it just alters how the software reactes to sense conditions. Regards, Gary (the Econo-Probe is not produced by Arnie.)
Arnie? Am I the only 1 having an issue with my G540? If the LED works the probe signal doesnt, if I flip the wires the probing process works but the LED doesnt. I am running a 48vdc ps to the G540. Should I have an additional resistor in place?
CncObsession 4 months ago
@CncObsession Could be 2 things. Easiest is reversing the sensing for probing in the Mach3 setup. I think that will solve it. The other, (less likely to be the problem) is to reverse the polarity of the LED. The Gecko is setup for a normally closed sensing circuits. But changing the the sensing polarity doesn't actually swap the polarity of the connections. it just alters how the software reactes to sense conditions. Regards, Gary (the Econo-Probe is not produced by Arnie.)
whivideos 4 months ago