dude the bad thing about 2.2 liters is once the bottom end goes you got to rebuild although they will continue to run, they're kinda like a 225 slant six they go forever whether taken care of or not
@nikorussion16 spun bearing. I replaced it and it runs lol. Same crank and rod, only did a bit of sanding with 600 grit paper to make sure it was smooth.
dude the bad thing about 2.2 liters is once the bottom end goes you got to rebuild although they will continue to run, they're kinda like a 225 slant six they go forever whether taken care of or not
71DusterFreeks 1 year ago
either rod bearings or a bent valve or the hammer is getting a flat spot
nikorussion16 1 year ago
@nikorussion16 spun bearing. I replaced it and it runs lol. Same crank and rod, only did a bit of sanding with 600 grit paper to make sure it was smooth.
supermoonbeam 1 year ago
@supermoonbeam sweeet good job man
nikorussion16 1 year ago
I need to put up a new video, but I pulled it apart adn I had a spun bearing. I put a new one it and it runs. Bit of piston slap, but it runs.
supermoonbeam 1 year ago
Nice car though!
LauxHawk 1 year ago
I'm gonna change out the rod bearings and the mains I can change out without pulling the trans or crank pulley
supermoonbeam 1 year ago
Ow, sounds painful. Rod bearings probably
Infinitrium 1 year ago