losi 1/24 micro SCT 4WD brushless speed runs 10250kv 3S 11.1V lipo 17T

[TheQuinn04]

do u live in tennessee

[exit44joe]

How long do your batteries last for the 17t pinion vs the 14t pinion?

[aricars6263]

is it hard to replace spur gear, if so can you show a how to video on how to do it? would apreciate it probobly others to. thanks

[bdseidler]

Hay to all you go fast freaks, I just bought a full set up for my SCT 4wd truck.

I found that you get the most bang for your buck with just getting a 2cell Lipo and charger. Wow what fric'n difference. But then I put a bushless motor w / ESC

new reciever and geared it up for redickulas fast. Almost too fast.

[sheilstar12]

how fast is it with the brushless and with the 17t spear gear or grear

[smashNgrab5953]

dose it do wheelies?

[whotubeblows]

damn that thing moves. good work!!!

[cesar11duran]

So is it faster with more teeth or less teeth?

[wolfxx66]

@cesar11duran more

[wolfxx66]

@cesar11duran more

[tucber37]

Are there any other parts other than those that come with the truck or arein your list below that are needed to achieve the setup that you have in the video?

[tonteeclat]

could you tell me if its better to used the 8750kv what is the difference ? is it faster

you run on 11,1v your 1/36 esc run ok with that ? because on the losi site the input voltage range is 7,4 v...

[DustyonTA]

@tonteeclat i know, that's weird. the esc comes with a programming card that enables 3S set up. and it works fine on 11.1. i like the 10250kv. they are pretty much all the same price so why not go big?

[eurozx5]

@tonteeclat The older programming card/esc could only handle 2s but the newer units handle up to 3s. Nice vid btw, that thing screams!

[RC240]

Is it brushless combo same for micro-t?

[DustyonTA]

@RC240

parts used were:

micro-T 17 tooth pinion

LOSB0874 11.1 lipo/charger combo

LOSB9530 xcelorin 1/36 ESC

LOSB0830 27Mhz receiver/3 wire servo combo

LOSB9545 10250kv sensorless brushless

[SpartanDara117]

@DustyonTA im lookin to get all this and a scheer CF chassis for my micro rally. Can the car handle all the power with ur setup? im gonna be using the 2s lipo thats specifically designed for this car. Have you had anything break on yout yet? stripped gears, melted pinions, etc?

[YourFriendlyMe]

very very impressive what are all of your upgrades and where did you buy it?

[DustyonTA]

@YourFriendlyMe thank. i listed the parts in another comment. i made an aluminum chassis but i dont like it. its too thick, i'm gonna start over.