2000 SS M6 Dyno runs with MS4 cam

[Bigmaker223]

How much did the cam give you alone ?

[WS6Outlaw]

man suks for me then i got everything the same as him on my trans am just ms4 cam tune full bolt ons stock ls6 intake 6 speed 4.10 gears and im running on 27s et streets but mine ran between 12.2-12.3 constantly dont know y his ran quicker maybe hes got something differrent but still i thinks its quite a difference dont know if it might be the gears or maybe the tune wasnt right

[2jzsupra1]

was ur cam 111 or 112 lsa?

[nomorev6]

did you use your stock valve springs and push rods/ also did that cam murder your mpg

[sskid99]

I HAVE BABY CAM AND LT HEADERS...I MADE 360/366..

[besstrokednova]

I haven't posted in a while kinda forgot about this video. But the car made 404/385. and with a set of 26" et streets, later that day after the dyno the car went 11.79 at 119.

[gunshin25]

The back tires should always stick out farther than the front ones, on any camaro.

[PrimitiveStrikeForce]

what does m6 stand for?

[rodneyrick]

@PrimitiveStrikeForce manual six speed.

[rodneyrick]

@PrimitiveStrikeForce manual six speed

[mylilpony71]

@PrimitiveStrikeForce 6 speed

[G0TFuel]

Sounds good..Black ZR-1's really make the car

[lplswon]

sounds like a loose dyno? numbers would say otherwise though.

[braheem35]

and i thought my ms3 sounded good

[jc8liter2388]

hey does your cam...have a 111 or 112 degree LSA

[765travis]

Charlie from harrison?

[praetorian2150]

sounds like the torque is massive at the right rpm of course

[SSCONCEPTZ]

how much power did it make? so this cam without a tune wouldnt be good rite?

[camarosam]

would not be good at all.

[35057]

@SSCONCEPTZ never drive a fresh cam install car for very long un-tuned.

[sixpack2go02]

wats your LSA?

[82v8s10]

are you on stock heads and what intake are you running i want to go with this cam on mine

[besstrokednova]

stock heads, stock bottom end, stock LS6 intake. full bolt ons custom ORY. cam is badass.

I have the motor for sale if anyone is interested.

[82v8s10]

did you fly cut the pistons for the valve clearance. what rpm are you running

[besstrokednova]

no fly cutting, pulls were made to 7200. Motor as ARP rod bolts as well.

like i said, its for sale and runs perfect.

[82v8s10]

dont need motor just curious i am going with ms3 and 150 shot

[besstrokednova]

cam is awesome, tune does wonders! i would never go back to my small cam.

[35057]

@besstrokednova Until you run one like mine.. xD made 414/372 @ TSP. I call it my "baby cam"

[SydewayzSS]

hows that cam working out? no regets?