The clock is on the low voltage side and does not need to be isolated. The FET gate control signals are isolated from high voltage side using the Si8234 on the POL board. The Si8234 has built in isolation as well as gate drive capability.
Please qualify your question on "how good"? Do you mean what is the pulse width distortion?
Awesome man...
antijames001 5 months ago
Allow me ask different way, this is my confusion about "bits per second" vs. "bandwidth in Hertz"
Let say if the part is rated at 150 Mbps, can I use it to transfer clock signal runnin at 150MHz ?
Thanks in advance
tokyo1943 7 months ago
@tokyo1943 150MHz clock equals 300Mbps, which is beyond the bandwidth of isolators.
ViralSilabs 4 months ago
The clock is on the low voltage side and does not need to be isolated. The FET gate control signals are isolated from high voltage side using the Si8234 on the POL board. The Si8234 has built in isolation as well as gate drive capability.
Please qualify your question on "how good"? Do you mean what is the pulse width distortion?
ViralSilabs 8 months ago
The voice pick up was so bad. Can't hear the voice clearly.
PansonAudio 1 year ago
So how good is the data after re-clocked (or recovered) at the other side ?
The clock require twice as fast as the data. How do I isolate the clock?
tokyo1943 11 months ago