@pop25811 It was a technical failure, BEC voltage dropped, no control of the heli.
I had no problem at the last two flights, it was approx. 7 degrees cooler at that flights. But the main problem are the E-MAX ES08A servos, they are pulling too much peak current. I think they are just too cheap for the heli, but they are fine in my plane......
@muni86 No, the RC receiver "Multiplex RX-7 Synth DS IPD" is defective! Excellent range but loss of control sometimes. There is also a jerky servo output when moving the controls fast.
So sorry to see the crash, hopefully not too expensive. Thanks so much for posting your setup, that is greatly helpful for people like myself who have never tried FPV but would love to get into it. Please post back if you ever make a final decision what cause the crash. I had a a similar crash when one of my cyclic servos just died without warning.
I stopped watching the moment I heard that awful music.
flightoftheunknown 3 weeks ago
was anyone hurt ?
MrMarijuanaKills 1 month ago
@MrMarijuanaKills Yes, my ego....
muni86 1 month ago
Dont waste your money on a clone dude
FPVUAV 1 month ago
i think it craches because of the music!
hallobaaaby 1 month ago
was it worth uploading this vid? I think not.
yeogav 1 month ago
Why are the blades always broken and flybar bend???
azezrtyuuiopqsdfghjk 2 months ago
;-(
Blackenedbarman 3 months ago
and ur boom is still ok .. lols if that was mine my boom would of gone .. always does for some reason..???
even on the lightest landings.. nice setup though.
MrProjectdjim007 4 months ago
@MrProjectdjim007 It was bent down slightly. I could fix it with my hands, but very exhausting.
muni86 4 months ago
Upps :D
I had the same problem :D
lennart296 4 months ago
Forget the helicopter, at least you didn't hit the GUY!
cracker442 5 months ago
@cracker442 I am that guy ;-)
muni86 5 months ago 5
Oh
MegaRallycar 6 months ago
@TestLab51
Do not make an early conclusion.
Everybody can have an accident even best of us.
:]
pop25811 6 months ago
@pop25811 It was a technical failure, BEC voltage dropped, no control of the heli.
I had no problem at the last two flights, it was approx. 7 degrees cooler at that flights. But the main problem are the E-MAX ES08A servos, they are pulling too much peak current. I think they are just too cheap for the heli, but they are fine in my plane......
I'll replace them with the Hitec HS-65 HB
muni86 6 months ago
@muni86 No, the RC receiver "Multiplex RX-7 Synth DS IPD" is defective! Excellent range but loss of control sometimes. There is also a jerky servo output when moving the controls fast.
The E-MAX servos are excellent so far!
muni86 3 months ago
Good music choice there! :)
kyrkbymannen 7 months ago
i found out tress block my video signal lol .. i did the chicken dance .. i need a dazzle to record thanks for the vid .. hope your gear took it well
420choky 7 months ago
@420choky only the cable to the video transmitter unplugged at the crash
muni86 7 months ago
that makes my eyes rain.
SuperMiller1972 7 months ago
They all have to eat it sooner or later. ;) Sorry for your loss.
SvenOkonomi 7 months ago
So sorry to see the crash, hopefully not too expensive. Thanks so much for posting your setup, that is greatly helpful for people like myself who have never tried FPV but would love to get into it. Please post back if you ever make a final decision what cause the crash. I had a a similar crash when one of my cyclic servos just died without warning.
8180634 7 months ago
@8180634 only approx. 50 Euro
I think the BEC of the ESC failed
Or the RC receiver had a loose contact but that's very unrealistic.
I'm taking the 4A Henge UBEC next time
muni86 7 months ago
I'm glad I'm not the only one!
locouk 7 months ago