91 f250 351w efi True Dual STRAIGHT PIPES

[Sexymanye419]

Are you running both pipes right from the manifolds? and what did u do with the o2 sensors



[dixiemudnut]

@Sexymanye419 theres about 3 feet of pipe after the manifolds and then they come close together and share an 02 sensor, right after that was a dual inlet cat, i cut it off there and ran the pipes back, that way i didnt mess with the sensor and i have no check engine lites

[Sexymanye419]

@dixiemudnut Thanks bud.... badass truck i got the 351w too in my 96 f150 and love it, FORD FOR LIFE!!!!!

[NorthAmericanArcher]

does this have cats?

[dixiemudnut]

@NorthAmericanArcher Negative.

[NorthAmericanArcher]

@dixiemudnut ohk and how did yojuu get the 8 lug rims to fit i have a 92 and it has a 5 lug and im getting 16's but idk how to get them to work

[dixiemudnut]

@NorthAmericanArcher hold r u sayin u have a f250 with 5 lug bolt pattern?

[NorthAmericanArcher]

@dixiemudnut no f150 with a 5 lug pattern

[idiforddiesel]

what are the chances of cops pulling you over for the noise of your vehicle? cause im thinking of doin this to my 351w

[dixiemudnut]

@idiforddiesel it depends where u live, but so far ive had zero run-ins with the law somehow, u just gta be a lil cautious with the gas and be mature about it..im 19 and ive had that setup but with bigger tips for awhile now and no problems

[idiforddiesel]

@dixiemudnut and u dont feel like you have lost power or anything like that how bout mpg?

[dixiemudnut]

@idiforddiesel gained high end power, lost some torque, and dropped 1 mby 2mpg but not much 

[joeyf504327]

@dixiemudnut thats because its not tuned for your engine, if you got tuned straight pipe your mileage, torque, and hp would go up : )

[dixiemudnut]

@joeyf504327 im looking for a chip now, kno anybody that makes one for a 91 351w 5speed ford?

[joeyf504327]

@dixiemudnut well no, but i wasn't talking about a tuned chip, i was talking about tuned exhuast pipe length, the reason you lost power is because the exhuast pulses are out of sync with your engine, it should be as a pulse is leaving the tail pipe a cylinder opens its exhuast valve pushing the exhuast gases into the manifold, but at the same time the pulse that was leaving the pipe created a small vaume which pulls the gases out of the cylinder at the same time, if tuned you get a lot of pwer

[joeyf504327]

@dixiemudnut here try performancechiptuning(.)com or an edgeproducts(.)com or even a bully dog good luck though

[kluekluxklan1]

Bad ass truck man im about to get a 1998 c/k1500 extended cab z71 trying to fid nice loud pipes message me bake for loud ass pipes please and thanks

[dixiemudnut]

@kluekluxklan1 i dont know how to message u but on ur truck, tell the muffler shop u want true dual straight pipes made with 2.5in pipe and ask for 4in tips angled at 45 degrees out the back, theres also a way u can do it yourself with flexpipe from a auto parts store...

[kluekluxklan1]

@dixiemudnut ok thank you anything else I should know

[smc13s]

thats bad ass man i love older trucks. I'm a chevy guy but i appreciate any badass truck. check out my vids

[dixiemudnut]

@smc13s thanks man! ill check it out

[123ewq]

sounds great, real mean lope to it for no cam.

[dixiemudnut]

@123ewq thanks! i think theres some bad valves on the right side thats why that side sounds different...

[dixiemudnut]

@RebeltilliDie45 thanks man i will, it looks like a seat cover but its actually just a thin pillow laying in the seat

[Drummerpwilson182]

Sounds nice man. Are there catts on it??

[dixiemudnut]

@Drummerpwilson182 Negative, no cats

[idiforddiesel]

are you gonna put a lift on it?

[dixiemudnut]

@idiforddiesel nah im gna sell it

[idiforddiesel]

@dixiemudnut ah really? thats a sweet truck

[NorthAmericanArcher]

so you just have 2.5in piping with 3.5 in tips? no glasspack or anything?

[dixiemudnut]

@NorthAmericanArcher Correct, in this video its 2.5in from the manifolds to the tips in the back, with two sections of flexpipe about 24in long before the rear axle where i deleted the glasspacks.

[NorthAmericanArcher]

@dixiemudnut alright thanks, sound great btw!

[EJthecountryboyGRAY]

So what part of bama are you from bro,I'm from the T-town area,and are you gonna get more vids up,I love the way your trucks sounds,need to get a drive by!

Also,where is the drop bumper from,looks good!

[dixiemudnut]

@EJthecountryboyGRAY im from morgan county, got alot of friends at bama, ill try to get more vids up sometime when i find my camera ha, not sure where it came from but it's a 20k lbs rated Hercules towing bumper, idk if they make them anymore though...

[EJthecountryboyGRAY]

@dixiemudnut Oh cool,I almost forgot I commented on this video,ha.

Ok,look forward to more clips of the truck! 

[dkhill27]

That's a beast!! Love that sound!! I have a 77 ford 150 lifted with a 400 with straight pipes and I just love the sound it puts out!! My mic on my cam doesn't do it any justice at all. Had glasspacks on it took them off wasn't loud enough for me. It pisses my neighbors off when I start it up at night to go somewhere. But its my mud/play truck. Check it out on my channel

[dixiemudnut]

@dkhill27 ha I did the same thing!...had glasspacks and wernt loud enough and this camera doesnt EVEN get the real sound and plus the truck was cold, sounds a whole lot better when warm...

[dkhill27]

@dixiemudnut Oh yeah it sounds alot better warmed up. And being my truck is a 4 speed going thru the gears sounds badd ass!! 

[OnusofStrife]

Love that sound. I have a 91 f250 also 351w 5 speed 4x4. Love it. Rusty as hell but is a beast of a truck.

[dixiemudnut]

@OnusofStrife i love these trucks, but not the MPG haha....keep changin that oil and drive it forever man

[OnusofStrife]

@dixiemudnut Plan on it and in the mean time fix the rust and get it repainted. Its originally black and i'm gonna make it black with silver two tone down the middle.

[browns0516]

nice truck man im looking at a 91 f250 with the original 351 in it with only 33000 miles on it

[dixiemudnut]

@browns0516 Thanks man, sounds like you found a cherry! Its rare to find one of that year with only 33k on it...Good luck and happy wheelin from Alabama

[EJthecountryboyGRAY]

Dude,this sounds like my dodge(good)

I know a guy here in bama with a truck like this,5spd,straights,ext cab,but his is maroon,I love to hear his truck.I also have a chevy thats straight piped and me and him started reving at each other on a busy bridge(bet everyone thought we were nuts) If you still have this truck you should do a take off video and more and upload it.By the way both my trucks are on here(check 'em out).Nice truck!!!

[meanrob06]

damn i wish mine was a 5 spd

[dixiemudnut]

@meanrob06 u cant beat it, 214k miles and zero problems, just replaced the clutch for the first time

[colleenisepic]

what does that black and white bumper sticker say?

[dixiemudnut]

@colleenisepic "THE BEST HOMELAND DEFENSE IS AN ARMED CITIZEN"

[JIcaseman]

what size is the exhaust pipe on there

[dixiemudnut]

@JIcaseman its all 2.5in

[JIcaseman]

yea it does thanks man and that truck sounds and looks awesome

and were cuttin both cats off and just running off the headers and its goin to be one pipe back and then y pipe and have duals in back

[dixiemudnut]

@JIcaseman nice, could u make a video?

[JIcaseman]

yea it does thanks man and that truck sounds and looks awesome

[JIcaseman]

is there a cat on that truck cause i have a 351 with striaghts goin on pretty soon so just wonderin if i should leave the cat on or not

[dixiemudnut]

@JIcaseman Nope theres not, to do a true dual system like mine u hav to cut the cat off, if u left it on there u would hav to run just one pipe back behind the cat to a y-pipe and then dual tailpipes which really doesnt sound good unless mby u gutted the cat. Thanks for the comment i hope this answered your question

[Metallica0493]

sounds awesome, love the rebel flag stuff

[dixiemudnut]

@Metallica0493 Thanks man

[funnyduck4]

finally! i found someone with the same bumper i got on my 87

[dixiemudnut]

@funnyduck4 which bumper front or back?

[funnyduck4]

@dixiemudnut the front one

[idiforddiesel]

looks like you take it offroading quite a bit lol

[dixiemudnut]

@idiforddiesel haha i do every chance i get

[idiforddiesel]

sounds SICK, my 89 f250 also has custom exhaust but thats it everything else is dead stock. long live the 351s EFI

[dixiemudnut]

@idiforddiesel amen. i cant kill that motor i maintain it properly and give it hell all the time and its never skipped a beat and doesnt tick any or make wierd noises. My buddy will have my 5x22in(!) tips done soon and i will put those on and make a video. Hopefully i can position the camera for better sound this time. Thanks for the comment.

[bigntastyV8]

Hey did you have to trim the fenders or anything at all to get 35s on it? Ive got an 88 regular cab F350 stock height and wondered how close the 35s would be.

[dixiemudnut]

i did not have to trim the fenders at all to make them clear. the truck does have a minor 1.5 inch skyjacker add-a-leaf that was installed way back in 1992 and has sagged to approximately to stock height again due to the weight of the winch and bumper combo and age. 35x12.5s should fit on your truck no problem at stock height unless you have the diesel motor which is heavier and makes the front of the truck even lower than mine was at stock height. i hope this helps. thanks for the comment.

[lp684]

I'm having trouble finding a bull bar for my 87. Its got a 460 and a 4 speed....4 in with 35s and I can't find a good bumper for it.

[dixiemudnut]

try ebay or somethin the one i got my dad bought it back in 92 when he bought the truck its a warn trans4mer kit, 8274 winch

[dixiemudnut]

im so sorry its not a trans4mer its a combo kit

[123ewq]

What kind of long tubes are you gettin'? its impossible to find aftermarket headers for my 89 250 with a 5.8, i ended up with some BBK 302 mustang shorty headers, they fit fine though. I'm running no cats to a 28in glass pack and have a 6in lift n 38in tsl's. Nice truck man

[123ewq]

also, what type of bull bar do you have? i can't find many options for that year 250's.

[dixiemudnut]

its a warn combo kit bought back in 93. its REAL sturdy if you can find one on ebay or somethin buy one