Can you send me you block diagram in Labview please its for a proyect and I barely understand how to put it in Labview! My email is amy_power14@hotmail.com THANK U VERY MUCH!!!
hiiii....i need ur help in this....i have just started using LABVIEW n i dont knw how to interface it with the hardware..so pls help me i'll really appreciate..
no problem, if its a thing you're considerign setting this up yourself for a college assignment or somthing let me know maybe you might be interetsted in the report for it?
Do I need that National Instrument Interface Device in order to run that motor? If I use the parellal port of the computer, will it do the same job? Probably that interfacing device is very expensive but provides easy control of the motor or any other output control device right???...
yeah i used the 6210 National instruments I/O module or DAQ Module. its roughly $500.
you cant use the parrallel port of the computer due to power rating of the motor. you'd kill your laptop/PC. the module allowed for easy interface with labview and acts as a buffer bewteen control signals and power signals. the motor is tied up to 12V power supply, the control signal is activated by the labview sub routine and applied VIA the NI DAQ module
This has been flagged as spam show
Can you send me you block diagram in Labview please its for a proyect and I barely understand how to put it in Labview! My email is amy_power14@hotmail.com THANK U VERY MUCH!!!
memi1492 1 week ago
Useless go make fan boy music vids
matrix49A 1 month ago
hiiii....i need ur help in this....i have just started using LABVIEW n i dont knw how to interface it with the hardware..so pls help me i'll really appreciate..
vinay331 2 months ago
is this possible to controll the stepper motor with usb 6008...
that too 2 bipolar stepper motor simultaneously
svijay1991 2 months ago
no problem, if its a thing you're considerign setting this up yourself for a college assignment or somthing let me know maybe you might be interetsted in the report for it?
ohjaysus28 4 months ago
Thank you for that advice. It was very helpful
RedAppleLondon 4 months ago
Do I need that National Instrument Interface Device in order to run that motor? If I use the parellal port of the computer, will it do the same job? Probably that interfacing device is very expensive but provides easy control of the motor or any other output control device right???...
RedAppleLondon 4 months ago
@RedAppleLondon
yeah i used the 6210 National instruments I/O module or DAQ Module. its roughly $500.
you cant use the parrallel port of the computer due to power rating of the motor. you'd kill your laptop/PC. the module allowed for easy interface with labview and acts as a buffer bewteen control signals and power signals. the motor is tied up to 12V power supply, the control signal is activated by the labview sub routine and applied VIA the NI DAQ module
ohjaysus28 4 months ago
@ohjaysus28 is it possible to controll the two bipolar stepper motor with usb 6008
svijay1991 2 months ago
This has been flagged as spam show
agradeceria pueda mandar el codigo mividasertu@hotmail.com
diadelpato 5 months ago
lmao
vaunstone89 7 months ago
After seeing the video I left my project and played bring me to life music video !!
vaunstone89 7 months ago
This has been flagged as spam show
Do you have a copy of that vi?
kirbyl8 7 months ago