SSG Fan - Watching Batteries Discharge and Charge

[overunitydotcom]

As the motor uses up the power mechanically you will

have a longer running time with the Bedini back and forth switching,

than run the fan on each battery alone and add these 2 running times

up.

[overunitydotcom]

If you would use a lower drag motor you could probably increase the charge on bother batteries,

if you have the right pulse waveform to charge up your batteries.

Just show us a few scopeshots, so we can see the waveform on a shunt rsistor, so that we can see the current waveform you use to charge up the battery with. Many thanks.

Regards, Stefan.

[MrArrow1961]

Dear Scroch you said - "The windings need to be wound in Rodin coil fashion but in some type of SUSPENSION such as foam rubber. This way a RESONANCE may be accomplished in tune with the Schumann resonance. Then the energy can be amplified."

I want to know the efficiency of last part that is called energy amplifier. Do you think that there are such amplifiers that has 100% efficiency? I am not sure on this on 99,5%...guess we are looking at wrong side to find phenomena of >100% efficiency.

Rob

[ScorchGD]

@MrArrow1961 Please forgive me, I used that term in a general sense. I am thinking in terms of some kind of step up transformer, or other system, that may accept a low frequency, long wave, resonance generated by a harmonic (near the Schumann resonance), and convert it to something more useful with a higher frequency. Could be just another toroid coil, or two, that operate at a higher harmonic. I am just guessing. And the original TPU videos are very intriguing.

[MrArrow1961]

@ScorchGD you know ,Schumann resonance is OK, but all these are very complicated to pass relevant simple tests in the way. We need instruments with memory etc...to log all results for further research deep analysis. Probably some one will accomplish this task , by this guys will be from very reach research laboratories, not us, sorry. Actually buy this information in the internet we are pumping up jobs and money not for us, not fro general people to copy and save their families.

[MrArrow1961]

watch?v=fveMcH41WKU



[MrArrow1961]

Hi dear Scorch,

Bedini him self refused that batts can be changed by their place. If we will change batts he said to Russia correspondent, then both batts will be discharged. Sorry, I did not found this video below in English. Actually you prove by your experiment his words.Only what is positive can I see here – in such setup B batt will be out of sulfatation , and will go up by its normal written capacity. That is true because there are high impulse voltage at B batt side.

Truly,

Rob

[ScorchGD]

@MrArrow1961 It is my belief that Bedini's systems CAN work. Just not sure if its very practical if they require a pair of huge battery banks for a home power system. See: "Practical Guide to Free Energy" wwwDOTrodscontractsDOTws/docs/­Practical_Guide_to_Free_Energy­_Devices.pdf

[min2oly]

your SCR cap dump does not seem to be working. Have you scoped it?

[ScorchGD]

@min2oly I did when I originally built it. It is switching, but at a pretty high rate, so not really visible on the DC meter.

[ScorchGD]

@min2oly Yes. See: wwwDOTrodscontractsDOTws/image­s/projects/PulsedMotor/fan/fan­2/

[GuardianZeus21]

It is my understanding that you cannot use a battery that has been charged with radiant energy in an Inductive Load only in a Resistive Load such as a bulb filament. If you wish to have a high capacity Either/Radiant battery you need to charge up with Radiant and discharge using only a resistive Load, do this several times. You will notice the capacity and Peak voltage of the battery will soon Increase. It will also take less and less energy every time after to charge it back up with Radiant.

[ScorchGD]

@GuardianZeus21 I have already jumped through all those hoops in the past. Been there; done that. Including building the trifiler system with full wave rectifier and timing circuit from the "Energy From the Vacuum" book. And worked with many different types of batteries as well as Rick's COP tracking software. Still seeking to discover a true, self sustaining, system. Or COP greater than 1. I've been CLOSE but not over the top yet.

[GuardianZeus21]

@ScorchGD So even after creating an either battery you were still unable to get a COP grater then 1? My Understanding is that a self running fan for instance requires a multistage circuit that shuffles the different energies around and keeps them separated. Kind of like what Tesla used to do with his multi coil setups. Simple circuits are almost impossible as the components were not designed for that type of energy. All good work tho and thank you for your posts.