My parents have an RCA scenium lcd television and it has no sound but the picture is fine. They have enlisted my help because I repaired my own washer and dryer and they call me Ms. fix it now. I have to say that although your videos are extremely informative, I am at a loss here and do not know where to start. Please help? Do you know what could be casuing the problem?
Hi there, a lot of technicians here in philippines uses LAQUER THINNER and a toothbrush, put some laquer thinner and brush the board so we wont have to use sand paper and scratch the board, it cleans the oxidized soldered connections. Harold O. Rahl from Philippines
Always ask if tv was dropped or hit.I always start repair from checking board(s) condition,cracks.Any suspicious solder points like elements which getting hot,radiators,capacitors,connectors i do solder straight away and test tv again.
im trying to figure out wats wrong with my combi microwave it makes my electricity fall out in my whole house like it using much more power as it should be also its not heating up to good the offen part also microwave aint to good this combi microwave is mayby bit over 1 year old -_- its a deawoo could use some help or tips
@007foppe I can't tell you what the problem is but if it were mine I would put it on a watt meter and see if its drawing excessive power. If was normal I would suspect your house wiring could be at fault.
@GrantsPassTVRepairs sorry about the english there like your show i wil first call the person where i rend the house from they changed alot on my electricity 1 year ago also then my combi microwave problems did start but slowly building up the problems now if i microwave something 2 min is enouge to get the short circuiting in my house
I also need to try and locate a new signalboard for a toshiba 43HT72. i thnk it is. i ran into 2 of these if your not extremely careful on removing the hyper modules, youll crack the board slightly, rendering convergence useless. unfortunately the traces are like microns away from one another...
My parents have an RCA scenium lcd television and it has no sound but the picture is fine. They have enlisted my help because I repaired my own washer and dryer and they call me Ms. fix it now. I have to say that although your videos are extremely informative, I am at a loss here and do not know where to start. Please help? Do you know what could be casuing the problem?
mommaaviles09 10 months ago
Hi there, a lot of technicians here in philippines uses LAQUER THINNER and a toothbrush, put some laquer thinner and brush the board so we wont have to use sand paper and scratch the board, it cleans the oxidized soldered connections. Harold O. Rahl from Philippines
haroldrahl 11 months ago
Always ask if tv was dropped or hit.I always start repair from checking board(s) condition,cracks.Any suspicious solder points like elements which getting hot,radiators,capacitors,connectors i do solder straight away and test tv again.
wowerman 1 year ago
im trying to figure out wats wrong with my combi microwave it makes my electricity fall out in my whole house like it using much more power as it should be also its not heating up to good the offen part also microwave aint to good this combi microwave is mayby bit over 1 year old -_- its a deawoo could use some help or tips
007foppe 1 year ago
@007foppe I can't tell you what the problem is but if it were mine I would put it on a watt meter and see if its drawing excessive power. If was normal I would suspect your house wiring could be at fault.
GrantsPassTVRepairs 1 year ago
@GrantsPassTVRepairs sorry about the english there like your show i wil first call the person where i rend the house from they changed alot on my electricity 1 year ago also then my combi microwave problems did start but slowly building up the problems now if i microwave something 2 min is enouge to get the short circuiting in my house
007foppe 1 year ago
than u sir u did a greate job keep going
narayansharma16 1 year ago
I also need to try and locate a new signalboard for a toshiba 43HT72. i thnk it is. i ran into 2 of these if your not extremely careful on removing the hyper modules, youll crack the board slightly, rendering convergence useless. unfortunately the traces are like microns away from one another...
THEtechknight 1 year ago
this is sad when i know every board you pick up and show in your video, exactly which TV they go in. lol.
THEtechknight 1 year ago
Hi Dave, new to this tv repair but find your videos really helpful & enjoyable! Thanks for the time invested in this.
anderson7901181 2 years ago