kyosho gx-12

[piercen10]

hey i have a question when i try to prime my engine, no fuel goes through the fuel lines but when i take one end out it squirts out. can u tell me how to fix it? thanks.

[kidreflex1]

@piercen10 check your engine gastket and rubber seal if thats lose it wont prime

[christhekoza]

not running because the ganazi the engine does not fit tightly into the next cog

[kidreflex1]

@christhekoza

thnx for the help :)

[kidreflex1]

trun it clockwise an till the wheels stop moveing and it stays runing best to do this off the ground but it might move abit but if u put it on the ground it will stop and see if the car is moveing

hope it helps:)

[Waggyjrjr]

i have this engine to. but cant get the tuning right on it. do you know the idle settings for it?

[kidreflex1]

and thnx for your help :)

[kidreflex1]

fuel comes out off the exhaust rubber joint i have 2 zipties on it but still it comes out and when i stop the engine if i tip the car on its side a very think oil comes out the cloure of my nitro fuel

[traxxasbasher8]

it is running ok is the fuel comming out of the exhaust? if it is thats fine they all have a little oil/fuel coming out try leaning it out a little

[kidreflex1]

i dont have a low end ? tell me if u want a vid of showin the carb and wat ends i have :)

[jthornley12]

Your running it too rich, Lean it out on low end and high end. Drive around, and lean the high end out 1/8 clockwise at a time. Same with low end. Tune high end first. If it runs good after tuning high end, do not touch low end :)