Hydro-Blast Solutions Video

[hottshott27]

that would be plaster not paint.

[filth606]

i know a man that can hold 2 40000 psi stinger hoses one with each arm without breaking of sweat

[eohunter]

you people need to wear proper ppe many people have died and been seriously injured from using ultra high equipment no joke

[madcat303]

its not like they are going to go over there foot....

[MihiLibertas]

is the paint just draining into the sewer..What a F^cked up World.

[flguy32501]

@MihiLibertas 1st, it's not the sewer, it is a drain for the pool. the "paint" you refer to is most likely marble/algae. even if it were paint, it is fully cured.

[RevJimiG]

Call 1 800 827 8790 M.P.W. industrial services and ask about Oscar and Felix they are 2 16 cylinder train motors used now for hydro demolitions they put out 10.5k but they have a volume of 500 gallons a minute and that would blow any blast gun to pieces. hell the hoses are 1 inch hammerlock and they blow from time to time

[thebiggids]

Dude, thats bullshit its impossible to hold a shotgun pressure washer at 40k PSI, trust me I work for a hydroblasting company...after about 20k you would be lifted off the ground and who knows what. I'd guess he is only going at about 5-8k PSI.

[eohunter]

I am a supervisor for hydrochem industrial services. generally speaking with lower pressures around 10k on a 2 to 3 hundred horse pump you are normally pushing up to a volume of 30 gal per min shotgunning. I have a uhp 40k waterlazer which if you are shotgunning produces very little backpressure and the total water volume is only around 5 to 6 gpm. the type of gun, dump system, and tip used also will affect your handling

[stewartbk]

eohunter, I worked for Waste Management, Hydro Svs. and Brand Precision and also blasted. Your correct in your analagy except NLB pumps for example are either 10K @125 hp =17 GPM, 10k @150 hp=25 GPM or 10k@250 hp= up to 63 GPM in 5th gear although you will never see that volume even through 3/4" HP hose. 20k NLB pump =7 GPM.Lucky to say never been cut but a few close calls.We also cut for hazardous atmospheres. How about you?

[Marc11211987]

Are you kidding me? I work for an Industrial painting/ coatings company and we have 3 Industrial ultra high pressure washers that run 40,000 psi. I have no idea what sallys you are talking to but we hop on that thing and run for 4 hours straight easily, its all about technique and a little old fashioned elbow grease my friend. It takes every bit of that 40,000 to strip some of these Flake tank linings, great for lead abatement too.

[ravingmadlunatic1975]

That goofball needs more than metatarsals. Chemical suit and face shield I'd think

[lainey500]

powerwashes paint away but does'nt reprofile the steel sa2.5

[hironistelrooy]

R.I.P paint

[naldopad]

what is the psi on that

[chosen11979]

Those u.h.p. roto nozzles are the shit. I'd like to get my hands on an NLB 50k set up and clean my driveway.

[kid0in0the0back]

ooo. didn't know you were into cleaning appliances :)