Charging your batteries with a gas powered alternator will make you go a little further ,yes.
But unless you can come up with an electric output equal to your usage while operating, ( 150 -300 amps continuous) then you will be spending allot of nonoperational time charging ( hours ) If what you are considering worked, We would have had Hybrid Vehicles LONG ago.
that is nice i have 1886 ez-go with 250cc the engine is blown. i also have the harbor fright 6.5 and just pulled engine today . what gear ratio did you use and how fast will it go.
hey MIchael i have done this to my golf cart. you need to take the old gear and weld another piece of tubing to it. And if it was electric make sure you change the gears or it will go 1 mph.
HI. I have a club car frame and I want to puchase a small sprocket on the differential. How r ataching the sprocket the existing gear to the rear axle. That is the only thing I need to figure out to finish my project.
HI. I have a club car frame andI want to puchase a small sprocket on the diferential. How r ataching the sporcket the existing gear to the rear axle. That is the only thing I need to figure out to finish my projct.
Charging your batteries with a gas powered alternator will make you go a little further ,yes.
But unless you can come up with an electric output equal to your usage while operating, ( 150 -300 amps continuous) then you will be spending allot of nonoperational time charging ( hours ) If what you are considering worked, We would have had Hybrid Vehicles LONG ago.
Rlmobile 7 hours ago
i have a snowmobile motor, now i just need the golf cart. would it be easier to put the motor in a gas or electric golf cart?
woodswarrior125 3 months ago
ummmmmmmmmm is that a gun at 00:0
jgolf1212 5 months ago
@jgolf1212 hes a cop
TheAssassin111 5 months ago
that is nice i have 1886 ez-go with 250cc the engine is blown. i also have the harbor fright 6.5 and just pulled engine today . what gear ratio did you use and how fast will it go.
robertallen80 7 months ago
Well is it done yet?
1fastsohc 7 months ago
@1fastsohc no i need to know what ratio would be best i have motor mounts welded all i need is throttle cable and gears and chain
robertallen80 7 months ago
where did you order your sprocket from to match splins on rear end.
cjl1064 10 months ago
Comment removed
TheAssassin111 8 months ago
nice gun and hand cuffs
TheKrazydreams 10 months ago
hey MIchael i have done this to my golf cart. you need to take the old gear and weld another piece of tubing to it. And if it was electric make sure you change the gears or it will go 1 mph.
retardproductions515 10 months ago
Comment removed
retardproductions515 10 months ago
This has been flagged as spam show
HI. I have a club car frame and I want to puchase a small sprocket on the differential. How r ataching the sprocket the existing gear to the rear axle. That is the only thing I need to figure out to finish my project.
Thanks,
Michael
acmesod 10 months ago
HI. I have a club car frame andI want to puchase a small sprocket on the diferential. How r ataching the sporcket the existing gear to the rear axle. That is the only thing I need to figure out to finish my projct.
Thanks,
Michael
acmesod 10 months ago