1968 Camaro "Reloaded" OER Frame Rail Replacement Video V8TV

[vcval]

looking good i like the htp spot weld drill bit , going to look it up shortly , i am using one that has a circular cutter , when it works it works well but i keep sliding around and it is hard to start sometime's

[vipexperformance]

I enjoyed the segment but was a little perplexed. Why not provide a weld all the way down each side of the frame rail for added strength? No need for all the drilling using that technique. Only the self tappers for adherence. By the way the weldable primer is a fantastic piece of attention to detail - especially on the area underneath the rail. We performed a similar job on an early (1966) mustang in our shop.

[V8TV]

@vipexperformance We wanted to attach this one the same way the original rail was installed. This way, the rail looked original (matching the other side) and the repair was undetectable.

[vipexperformance]

@V8TV I can appreciate your attention to detail with that approach.