Hi there, funny video. You have a cool dog. So how do I get the crank pulley if I have an anutomatic? Also, is this video a good reference point if I am doing the timing belt on a 2000 subaru impreza rs 2.5? Is your engine the same set-up as for my vechicle? Thank you!
On the driver side you will see a hole just on top of the transmission. Usually the clutch fork goes there on the manual transmissions. Remove the cap and look inside. You will be able to prevent the engine from turning if you prop something against the torque converter.
That is a good method to tighten the bolt, but to loosen it, just lay the pipe against the battery and bump the starter.
MilesFox 2 months ago
Hi there, funny video. You have a cool dog. So how do I get the crank pulley if I have an anutomatic? Also, is this video a good reference point if I am doing the timing belt on a 2000 subaru impreza rs 2.5? Is your engine the same set-up as for my vechicle? Thank you!
naturalmadeyo 1 year ago
@naturalmadeyo
On the driver side you will see a hole just on top of the transmission. Usually the clutch fork goes there on the manual transmissions. Remove the cap and look inside. You will be able to prevent the engine from turning if you prop something against the torque converter.
HuckThis1971 1 year ago
beautiful dog and excellent video. have a question about changing the cam seal when i change the timing belt. how do i get the cam pulley off?
oabus 1 year ago
@oabus
Before removing the timing belt, you loosen the 2 bolts with the car in gear. There is not much torque on them, they should loosen right up.
HuckThis1971 1 year ago
Thanks so much!
skumarjunk 1 year ago
excellent video. just wish there was better lighting because your knowledege is very valuable.
oabus 2 years ago
amazing, thanks, i like it thnxs.
TheSethsuarez 2 years ago
Thanks for posting these!!!
wheezer210 2 years ago