HB King v2 Heli with Bad Align 11t Pinion Bad 140t Main Gear

[cafediablo30]

u should hear th teeth just barly click when u move th main slightly back and forth,then maybe u'll have proper mesh,..another thing,...was this a fresh pinion and main gear,.if u ran that pinion for a while allready and just tried to put in a fresh main gear,..th pinion might have allready been worn out,..thereby causing th rest of th damage to ur main gear,..allways check the pinion before u put a fresh gear.

[deangoffe]

mesh with gears is fare too tight! have a small gap inbetween the gears but enough so the teeth are locked in abotu half way in

[400smallblock]

ur shits installed to way too tight of a tolerance...the gear mesh is too tight...

[shadowflyer101]

look up honey bee king 2

[shadowflyer101]

oops, look here instead.

rcuniverse(dot)com/forum/m_503­7490/mpage_79/key_/tm.htm

[shadowflyer101]

i can realate, i think the problem is that we had our pinions to close to the main gear. i did a few tests and it seams like that black film came up after i nuged the pinion closer to the main gear. you definatly want to replase it. go to here

rcuniverse(dot)com/forum/m_503­7490/anchors_6174122/mpage_80/­key_/anchor/tm.htm#6174122

[PatrickDo74]

Ya you must use 0.5 modus and not Align pinions

Is it not too much 10-11T with the 3900kv eSky?

Usually 10T for 3800kv and 9T for 3900kv. No?

[HeliPilotFlyer]

CORRECTION:

The Pinion is a 10t Pinion, NOT a 11t Pinion as stated in the video.  Sorry.