Do you know if the FENIX T1 can work without damage with 2x 3,6v CR123A rechargeable batteries? Cause i know the manufacturer says 2x 3v, but doesn't mention 2x 3,6... thanks!
Its nothing to be fixed that's the low battery indicator they strobe when the batteries get low so people running rechargeable can charge them before causing damage to li-Ion cells
actually im doing the strobing on purpose, its actually quite tricky to keep it strobing... you use low mode and press the 2 ends of the torch together, press too hard and it goes into full high mode, not hard enough and of course nothing happens... its quite trippy if you look into the beam, but you cant notice it if its actually lighting up a dark place for you...
it uses PWM to regulate brightness, the camera's picking it up that's all.
cjdelphi 2 years ago
the pwm is normally too high frequency to be picked up by the camera, as you can see from the low power non-flickering state
the flickering state is caused by insufficient power to sustain high mode
carmatic 2 years ago
Do you know if the FENIX T1 can work without damage with 2x 3,6v CR123A rechargeable batteries? Cause i know the manufacturer says 2x 3v, but doesn't mention 2x 3,6... thanks!
walkerzero 3 years ago
Both work.
jaseth1337 3 years ago
Its nothing to be fixed that's the low battery indicator they strobe when the batteries get low so people running rechargeable can charge them before causing damage to li-Ion cells
kevinjsand 3 years ago
actually im doing the strobing on purpose, its actually quite tricky to keep it strobing... you use low mode and press the 2 ends of the torch together, press too hard and it goes into full high mode, not hard enough and of course nothing happens... its quite trippy if you look into the beam, but you cant notice it if its actually lighting up a dark place for you...
carmatic 4 years ago
did you send it back? or fixed it?
junpower00 4 years ago