wont be hard to make an adapter. The loss in compression could be due to that gasket, im pretty sure it has to be a zinc type gasket not a paper one. Could be wrong but thats what i think it is, or the paper one is to thin.
it would be too hard to make. Which gasket do you mean? head gaskets must be metal the one im getting will be 2 pieces of copper with something imbetween.
Nice video Geoff...... From the looks of that older glow plug, it takes the same type of washer or seal like a spark plug uses..... but no worries, you have that NEW glow plug.... Can't wait to see your adapter... 5 Stars!!!!!!
Could you use a longer con rod to get higher compression?
codsixrules 1 year ago
@codsixrules probably but finding one would be difficult and the piston goes so close to the head it would only have to be about 2-3mm longer.
geoff390 1 year ago
Any progress since you posted this vid? I suggest performing a leakdown test.
giberish9 2 years ago
serious? iv got videos of it going.
geoff390 2 years ago
Sorry about that. I found the vid of it running about 15 minutes after posting my comment.
giberish9 2 years ago
haha ok
geoff390 2 years ago
sounds like aero start/ start ya bastard isnt as good as they say...
drz250gp 2 years ago
wont be hard to make an adapter. The loss in compression could be due to that gasket, im pretty sure it has to be a zinc type gasket not a paper one. Could be wrong but thats what i think it is, or the paper one is to thin.
brendonv101 2 years ago
it would be too hard to make. Which gasket do you mean? head gaskets must be metal the one im getting will be 2 pieces of copper with something imbetween.
geoff390 2 years ago
Nice video Geoff...... From the looks of that older glow plug, it takes the same type of washer or seal like a spark plug uses..... but no worries, you have that NEW glow plug.... Can't wait to see your adapter... 5 Stars!!!!!!
vidman008 2 years ago
like i said make an adapter its the best way or get that rebuild
30GB 2 years ago
Yea i will be
geoff390 2 years ago