Blazer Dash Bezel How To

[MrMorcillin]

Good job, thanx for taking the time.

[tbirdsport302]

Can you replace the bulbs on your Headlight Controls and your Rear Wiper Controls? If you can I'm guessing they are 194's also right?

[03canadianf5]

@tbirdsport302 You can, but the wiper controls use small bulbs that are soldered to the circuit board, and the light controls also use a small bulb, when you pull the headlight control out, you'll see a little grey disk with a flat-head slot, turn it counter clockwise and pull it out, you'll need to match that bulb type. I suggest going to the dealer and getting it.

[OleMissRebel867]

That's the first manual blazer 2nd gen I have ever seen...

[03canadianf5]

@OleMissRebel867 They're out there... Most of them are 05's though, like mine.

[britlynforever]

thanks man this rlly helped me (: could u do another vid on how to hook up subs and amp to the stock head unit? im too poor for a new one and also i like my steering wheel controls lmao (:

[03canadianf5]

@britlynforever I don't own this truck anymore, but if you want to keep your stereo controls make sure you buy a head unit that is InfraRed capable. Next you can buy a module that connects to the green data wire and will act as an IR Remote and will control any deck. If you just want a sub hooked up to your stock HU though, you can tap the sub wires into the rear speaker wires. Not as clear as an aftermarket HU with RCA outputs. I've had both, big difference.

[hondaaccourd5]

thanks, had no clue how to take it off to remove my head unit

[TheMreverything10]

dude this helped me so much!!!

big thumbs up!

[cragar72]

I just want to say thanks for your video. I had my dash cluster and bezel removed in minutes on my 1998 Blazer thanks to you. Take care.

[supersanchez1991]

what type of bulbs does it use? can i change the color of it?

[03canadianf5]

@supersanchez1991 #194 bulbs, you can get inverted wedge LED's from ebay in any colour you'd like.

[supersanchez1991]

bro, do you know how to get the clear plastic out of the speedometer? i want to get a Gauges Bezel Dash Trim

[jforgue76]

@supersanchez1991 After you remove the gauge cluster, the clear plastic part is just hooked on by a few plastic tabs. Very easy to remove with a flat head screw driver.

[IPUNTGNOM3S]

You my man, are a life saver/miracle worker, there may be many others who CAN do this, but you were the only one to put it on youtube. And we all hank you for that.

[dammitairmex]

Dude i effin love you for this vid. I have A dash light out and i didnt wana go to a shop cause theyd bend me over. Thanks now im sure i can do it myself!

S10 for life!

[03canadianf5]

@dammitairmex HAHA, it's good to be loved I guess lol.

[ktofere]

You don't gotta recailabrate the speedometer when u take it out do u?

[RichardSoullie]

hey i got a 2000 sonoma with the same dash and everything

i wanted to replace the dash lights with blue led's, but i couldnt get that plate off, because of my shifter, and my truck wouldnt let me take the key out when it was in neutral

do you have any suggestions

thanks

[MonsterrEnergyy]

your awesome man. im 16 trying to put in my new kenwood head unit. i had trouble but now, thanks to u, i got it! thanks bud!

[Snoopii27]

@MonsterrEnergyy YO HOW DID YOU REMOVE THAT SWITCH BEHIND THE DASH AT 4:01, CAUSE IM TRYING TO DO THE SAME THING. HELP ?!

[scottyBoland]

by chance would you know the dash illumination wire color? my switch in the dash burntt out again from bass, and so im looking just to simply bypass it to a toggle, Thanks!

my Suv is a 2001 Bravada just to be exact

[03canadianf5]

@scottyBoland No sir I don't know what the wiring schematic is for that stuff.

Maybe join up at Blazerforum . com or a simlar place and ask away?

[scottyBoland]

@03canadianf5 hey thanks anyway man, but no i tried posting a similar quesiton and well no one but a GM dealership has the schematics and color codes, and i refuse to pay 160 dollars for a 40 dollar illumination switch in the dash...

[03canadianf5]

@scottyBoland Pick 'n pull? Wrecking yard? LMC truck?

[scottyBoland]

@03canadianf5 nad bought used, just alot of crap went downhill recently including my 2nd starter in 6monthes luckily ACDelco will pick up the tab!

[Snoopii27]

@03canadianf5 YO I HAVE A CHEVY BLAZER 2000 AND IM TRYING TO INSTALL A NEW STEREO, SO FAR YOUR VIDEO HAS BEEN OF GREAT HELP BUT IM HAVING TROUBLE REMOVING THOSE SWITCHES BEHIND THE DASH AT 4:01, ANY SUGGESTIONS ?

[allangeeizme]

Awesome! I have to try and access an AutoStart module and the GM bypass module which are tucked up way in a corner behind the dash. This should help a lot!

Thanks for taking the time to record it.

[bradxdieden]

how did you get that last white plug? I for the life of me cant figure out how to unclip it

[03canadianf5]

@bradxdieden You've gotta squeeze it real hard, or use a small flat-head screwdriver.

[EzyStreetFilms]

Hey man, I just wann thankyou for this How-to tutorial. Ive searched online and have found nothing close to what you have described and showed. Can't even find guides on how to take this apart. Thanks again!

[03canadianf5]

@EzyStreetFilms

glad I could help... I went through the same thing, and that's why I made this.

[DBJF209]

help alot thanks

[GuinnessDrinker69]

I have an '04 blazer 4 door 4x4. And in your blazer guages are doing the same thing mine are, where they dont go completelly to the far left ( zero - 0 - ) position and im curious why and what could be causing the problem weither i got a bad gague going or its something electrical. U sound like a person who works in the service dept, so im relying on your judgement before i go to a dealership and they find out a problem and charge me an arm and a leg thanx..

[03canadianf5]

My gauges all jump back to 0 when I start the truck up... I don't work in a service department lol, I'm still going to school.