Pulse motor V3 preliminary2 - she spins

[terryclotf]

you got to think a lot bigger. in a couple of days i will post my motor. look for "30 Lbs Bedini"

[comwarrior69]

Hi terry,

I've seen your 30lbs bedini, nice setup...

I'm upto build 4 now, build 3 proved a concept for me so i've gone bigger... however, my original build 4 went TOO big and i had extra problems...

I've not done a vid on build 4 yet because i'm still sorting problems out... My curent status is on teep forums... teep [DOT] forumco [DOT] com

[Pwordchernoir]

Gfield..... btw were both on horizontal axis now...

[comwarrior69]

g-field... erm... yes, ok... places duct tape over mouth... then tapes hand to desk away from keyboard...

[Pwordchernoir]

whats is the coil temp Kev? is it running cold?

[comwarrior69]

the coil is still cold... even running at 200mA it's still cold...

I'm looking at more 'agressive timings' for my pulse motor...

[blulander1969]

whereabouts in the uk are you based comwarrior69 ?(69 YOB ?)

[comwarrior69]

first, 69 not for the sexual reference but because i take something turn it upside down and make it fit...

where in uk... M6 junction 17 area... ie south cheshire

[gazzaka]

lol

[comwarrior69]

the recovery system hasn't been changed so it should be about the same...

This was just a test to find any problems with the rotor... the real benefits are going to come with the new controll system... the back emf recovery disrupts the power recovery... the new system discharges the BEMF cap during the off pulse instead of the on pulse thus it won't affect the recovery coils...

It's a big build... mental note to self... leave more space between componants... [bangs head on wall]

[gazzaka]

N1, be nice to have a rough idea what kind of output voltage and current it is producing in that basic set up ;)

gl with all