"Since there is no load on the engine it will run at a higher RPMs with less fuel and in turn less oil, this will not supply the rod bearing enough oil and will result
in breakage. Be careful. Only run your engine at low rpms while it is out of the water."
Prob not a good idea to break it in out of the water.
1. BREAK-IN running should be done at a slightly rich setting. The needle valve should be set at a point just into this range from a four cycle setting. Run the boat in the water at maximum throttle for 2 minutes, then throttle back for approximately 30 seconds. Repeat this sequence until approximately 30 minutes of accumulated running time has been obtained.
AVOID MAXIMUM THROTTLE FOR LONG PERIODS OF TIME DURING BREAK IN and AVOID RUNNING FOR LESS THAN 5 MINUTE RUNS.
lol what a fucking idiot= one fucked engine = fucked viewer = LOL
pearlsatria 3 weeks ago
lol what a fucking idiot= one fucked engine
MrFlowrite 1 month ago
moron are you gonna crash the engine its gonna be to hoooot.
packe35 2 years ago
well that will be fucked lol.. its meant to be run in water you know
cleanmyroomornocar 2 years ago
Hey dude that motor is water cooled. you got to put it in the water. And like
footballrob34 said it is just a thunder tiger engine so who cares burn it up.
planeman1965 2 years ago
its just a thrundertiger who cares
footballrob34 2 years ago
dude u know it only works in water right
beardeddragonsrock12 2 years ago
engine break in......
pearlsatria 2 years ago
This is right from your engines manual..
"Since there is no load on the engine it will run at a higher RPMs with less fuel and in turn less oil, this will not supply the rod bearing enough oil and will result
in breakage. Be careful. Only run your engine at low rpms while it is out of the water."
Prob not a good idea to break it in out of the water.
Nightwishr 2 years ago
BREAK-IN
1. BREAK-IN running should be done at a slightly rich setting. The needle valve should be set at a point just into this range from a four cycle setting. Run the boat in the water at maximum throttle for 2 minutes, then throttle back for approximately 30 seconds. Repeat this sequence until approximately 30 minutes of accumulated running time has been obtained.
AVOID MAXIMUM THROTTLE FOR LONG PERIODS OF TIME DURING BREAK IN and AVOID RUNNING FOR LESS THAN 5 MINUTE RUNS.
Nightwishr 2 years ago
Put it in the water!!!!
pobnpooky 2 years ago
Comment removed
molecularcloud72 2 years ago
i'm not playing rc anymore.i turned my hobby to sportbike...anyway thanks for the comment.....btw your boat is nice.
pearlsatria 2 years ago
Comment removed
molecularcloud72 2 years ago
Comment removed
stuglas69 2 years ago
Comment removed
kolbyrowland 2 years ago
you stupid idiot its water cooled your going to over heat it fucker you dont deserve this type of engine play with electrics
30GB 3 years ago 2
amazing....!!!
lazirsuj80 3 years ago
my god!!! Put it in the water dick
cvcgac 3 years ago 2
not a good idea to run it without water or load
mypuppydog 3 years ago 2
Wer quält seinen Motor denn so lange auf dem trockenen????
bubi1407 3 years ago